Vanguard VG162S User manual

Fitting Instructions - Read instructions carefully before fitting and follow them for correct use
IN8160 Bulkhead - VG162S / VG162P
This FITTING INSTRUCTION is the property of VAN GUARDACCESSORIES LTD. and must not be used for
manufacturing purposes, copied nor communicated in any way to third parties without written
permission from VAN GUARDACCESSORIES LTD.
IN8160_B
Van Guard Accessories Ltd
Fair Oak Close, ExeterAirport Business Park,
Exeter, Devon, EX5 2UL
www.van-guard.co.uk
IN8160 - PAGE 1 OF 3
MA6030 X1
(RUBBER EGDING 950MM) FX4012 X5 (M6X16) FX4016 X5 (M6) FX4017 X10 (M6)
ME0361 X1
(BOTTOM)
VG162S = ME0336 X1
VG162P = ME0337 X1
(TOP)
FX4087 X21
(No14 x 1/2”)
!
DRILL (Ø4.5MM) X1
SPANNER (10MM) X1
PH SCREW DRIVER X1
TOOLS REQUIRED
??
1. You should note that it is the responsibility of the installer/s to ensure that when drilling holes in to your
vehicle to take fixings, care must be taken to ensure that the fuel line, tyres, fuel tank, wiring loom, exhaust,
bodywork and brake lines etc. are not damaged. Whilst every effort has been made to ensure our products can
be safely fitted, changes to vehicles sometimes occur so it’s always necessary to check before drilling.
If in doubt refer to the vehicle manufacturer’s dealership.
2. When drilling, use as short a drill bit as possible to prevent damage to the vehicle. Use corrosion protection
when drilling the vehicle.
3. Wear the appropriate protective equipment (safety glasses & gloves) while fitting this product.
4. Regularly inspect all fixings and parts.Any damaged or worn parts should be immediately removed the
vehicle and replaced.
5. Retain instructions for future use. It is important that the end user receives this document.
CAUTION - IMPORTANT NOTES

IN8160 - PAGE 2 OF 3
1
Position the top section on top of the bottom section with the return along the
bottom facing into the cab area and secure to the bottom section using M6x16 hex
bolts (FX4012), M6 washers (FX4017) and M6 flange nuts (FX4016).
Position the bottom section into the vehicle with the bottom return facing into the
load area. The top of the bottom section is marked with an ‘F’ as highlighted below
and the bottom return is the return with holes (not slots).
2
3 Once happy with the position of the bulkhead carefully drill 4.5mm through the
bottom sections fixing holes in the positions shown below and secure using
No14x1/2” self tap screws (FX4087). (5 positions along the bottom and 4 each side).
4
Please read the important notes on page 1 before fitting this product.
Fit the supplied rubber egding (MA6030) to the top bulkheads left edge.
BOTTOM RETURN FACING INTO LOAD AREA

IN8160 - PAGE 3 OF 3
Carefully drill 4.5mm through the top sections fixing holes in the positions shown
below and secure to the crossmember using No14x1/2” self tap screws (FX4087).
(6 positions along the top and 1 position each side).
5