Vanguard VG284-3 User manual

Fitting Instructions - Read instructions carefully before fitting and follow them for correct use
VG284-3 3 Heavy duty aluminium roof bars - Fiat Doblo 2010 on / Vauxhall Combo 2012 on
SUPPLIED COMPONENTS # DESCRIPTION QTY
This FITTING INSTRUCTION is the property of VAN GUARD ACCESSORIES LTD. and must not be used for
manufacturing purposes, copied nor communicated in any way to third parties without written
permission from VAN GUARD ACCESSORIES LTD.
IN8098_A - IW - 03/05/2013
Van Guard Accessories Ltd
Fair Oak Close, Exeter Airport Business Park,
Exeter, Devon, EX5 2UL
www.van-guard.co.uk
1
2
3
4
5
6
7
SUPPLIED FIXING KIT
VG284-3 - PAGE 1 OF 3
TOOLS REQUIRED: 10mm SPANNER / RATCHET
REAR BRACKET
MIDDLE BRACKET
FRONT OFFSIDE BRACKET
FRONT NEARSIDE BRACKET
TOP HAT
TOP HAT COVER
ROOF BAR
2
2
1
1
6
6
3
#DESCRIPTION QTY
1
2
3
4
5
M6x16 HEX BOLT
M6 SERRATED FLANGE NUT
M6x16 COACH BOLT
RUBBER WASHER
M6 SHAKEPROOF
10
12
12
10
10
12 3 4
1
3
5
6
2
74
5

The front roof brackets are handed to suit both sides of the vehicle and are angled to suit the slope of the roof. The
brackets need to be positioned on the vehicle as shown below with the top hat flange facing inwards.
VG284-3 - PAGE 2 OF 3
1
Secure roof brackets to the vehicles fixing points
using M6x16 hex bolts, M6 shakeproofs & rubber
washers. Ensure that the top hat flange is facing inwards.
3Place roof bars onto the roof brackets with the t-slot
facing upwards, secure using top hat brackets,
M6x16 coach bolts & M6 serrated nuts.
4
Remove roof plugs to reveal the vehicles fixing
points.
2
FRONT (HANDED) - ILLUSTRATION SHOWS OFFSIDEMIDDLEREAR

VG284-3 - PAGE 3 OF 3
Once in position tighten all fixings to 8Nm.
Periodically check all fixings.
6
NOTES:
Maximum load is 55kg per bar. Please check that the vehicle manufacturers
load bearing capacity for the roof is not exceeded. (Refer to the vehicle
handbook)
Periodically check all fixings.
Retain these instructions for future reference.
TIGHTEN
TO
8Nm
Flex the top hat covers over the top hat brackets into position as shown below. Ensure that the covers click into the
front and rear of the top hat brackets.
5
1. 2.
3. 4.