Vaporesso GEN AIR 40 User manual

USER
MANUAL
VAPORESSO GEN AIR 40

1ENGLISH
Thank you for choosing Vaporesso product.
Please read this instruction carefully before use
to ensure a perfect experience.
If there is any additional requirement about
this product, please consult the local agent or
contact us through our website:
www.vaporesso.com
Dimensions: 103.05 x 31.55 x 20.5 mm
Cartridge Capacity: 4.5ml(Standard)/2ml (TPD)
Coil: GTX 0.4Ω MESH COIL (26-32W)
GTX 0.8Ω MESH COIL (12-16W)
Battery Capacity: Built-in 1800mAh
Output Wattage: 5-40W
Display: 4 x LED Indicators
Charging: Type-C, 5V/2.5A
ENLARGED VIEW
SEPCIFICATION
Mouthpiece
Airow Toggle
Filling Slot
Rellable Cartridge
Coil
Power Button
Coil Hole
LED Indicators
Voltage Control Button
Type-C USB Port
ENGLISH

21 ENGLISH
Figure 1
Figure 2
Voltage Control Button
1. Coil Installation (Refer to FIGURE 1)
Make sure the cartridge is empty before installing
the coil. Insert the coil rmly into the cartridge.
2. Coil Replacement (Refer to FIGURE 1)
Make sure the cartridge is empty before replacing
the coil. Pull out the used coil and install a new
one rmly.
3. Fill the E-liquid (Refer to FIGURE 2)
Pull out the red silicone plug of the pod.
Fill the e-liquid through the lling slot.
Put the silicone plug back.
*If it’s the rst time lling the e-liquid, please
wait 5 minutes for the coil to prime.
USE INSTRUCATIONS

3ENGLISH
4. Adjust the airow
There is a black airow control toggle on the side
of the pod, you can adjust the toggle according
to you habits for dierent airow eects.
5. Install the cartridge
Put the cartridge with installed coil onto the
battery. Make sure they are rmly connected.
6. Check the Battery Level
The LED indicators will ash while vaping to
remain the battery capacity.
7. Voltage control
Press the voltage control button to adjust voltage
by 4 stages.
8. Charge the device
Connect the Type-C cable with the device
to charge the battery, all the LED will be on
gradually. When fully charged, all the LED
indicators will be always on.
9. Power On/O
Press the power button 5 times within 2 seconds
to power on or power o the device.
10.Start vaping
In the locked state, hold the power button and
inhale through the Mouthpiece. Release the
power button and exhale.
0%-25%
3.0V
25%-50%
3.2V
50%-75%
3.4V
75%-100%
3.6V
Voltage
Control
Button
Voltage
Control
Button

43 ENGLISH
PROTECTIONS
CAUTIONS
1. Please turn o the device when it is not in use.
2. Do not leave the charging device unattended.
3. Do not drop, throw or abuse your device, which
may cause damage.
4. Please use a standard USB output charger with
proper charging current and voltage range.
5. Keep away from the water or any ammable
gas, liquid .
6. Do not expose the device to direct sunlight,
dust, moisture or mechanical shock.
7. Do not expose the device to extreme
temperature. (Recommended temperature range:
-10~60℃ /14~140 ℉ while using and -10~45℃
/14~113 ℉while storing).
8. EEE Recycling: the product should not be
treated as household waste, instead, it should
be handed over to the applicable collection
point for the recycling of electrical and electronic
equipment.
Protections Flash Status of LED
Indicator
Short-circuit All lights will ash 5 times.
No Load All lights will be on
gradually and repeat 3
times.
Low Voltage All lights will ash 3 times.
Over Charging All Lights will be always on
Over Discharging All lights will ash 3 times.
Low Resistance All lights will ash 5 times.
High Resistance All lights will be on
gradually and repeat 3
times.
Overtime All lights will be on
gradually and repeat 3
times.

5ENGLISH
9. Battery Recycling: the product battery should
not be treated as household waste, instead, it
should be handed over to the applicable used
battery collection point for recycling.
10. Only have your device repaired by Vaporesso.
Do not attempt to repair it by yourself as damage
or personal injury may occur.
This rellable electronic cigarette is intended for
use with compatible e-liquid, which may contain
nicotine. Nicotine is an addictive substance
and it is not suitable or recommended to use in
following cases:
1. This device is not suitable for:
- Persons under the legal smoking age.
- Persons experiencing heart disease, stomach or
duodenal ulcers, liver or kidney problems, long-
term throat disease or dicult breathing due to
bronchitis, emphysema or asthma.
- Persons with an overactive thyroid gland or
experiencing phaeochromocytoma (a tumour of
the adrenal gland that can aect blood pressure).
- Persons taking certain medications like
Theophylline, Ropinirole or Clozapine and etc..
2. This device is not recommended for
- Non-smokers
- Pregnant or breastfeeding women
3. You may experience the following results
if you use nicotine containing e-liquid with
this product. If it happens, please consult a
healthcare professional and show them this
leaet if possible:
Feeling faint/Nausea /Dizziness/Headache /
Coughing/Irritation of the mouth or throat/
Stomach discomfort/Hiccups/Nasal congestion/
Vomition/Chest palpitations/pain or an irregular
heart rate
This device should not be used
by persons under the legal
smoking age.
WARNING

1FRANÇAIS
FRANÇAIS
1. Installation de Coil (Voyez la FIGURE 1)
Assurez-vous que la cartridge est vide avant
d’installer la coil. Insérez fermement la coil dans
la cartridge.
2. Remplacement de Coil (Voyez la FIGURE 1)
Assurez-vous que cartridge est vide avant
de remplacer la coil. Retirez la coil usagée et
installez fermement une neuve à la place.
3. Remplissez d'e-liquide (Voyez la FIGURE 2)
Retirez le bouchon de silicone rouge du pod.
Versez l’e-liquide par le trou de remplissage.
Remettez le bouchon de silicone en place.
*Si c’est la première fois que vous remplissez
d’eliquide, veuillez attendre 5 minutes, le temps
que la coil s’amorce.
4. Ajuster le débit d’air
Vous trouverez un sélecteur de débit d’air noir
sur le côté du pod, et vous pouvez l’ajuster selon
vos habitudes, pour diérents eets de débit
d’air.
5. Installer la cartouche
Placez la cartridge avec la coil installée sur
la batterie. Vériez qu’ils sont fermement
connectés.
6. Vérier le niveau de la batterie
Les voyants DEL clignoteront pendant le
vapotage pour indiquer la capacité de batterie
restante.
7. Contrôle de la tension
Appuyez sur le bouton de contrôle de la tension
pour ajuster la tension sur 4 niveaux.
8. Charger l’appareil
Connectez le câble Type-C à l’appareil pour
charger la batterie. Chaque voyant LED
s'illuminera en cycle. Lorsque la batterie est
pleine, tous les voyants LED sont allumés.
9. Marche/Arrêt
Appuyez sur le bouton d’alimentation 5 fois en
2 secondes pour mettre l’appareil en marche ou
l’éteindre.
10. Commencer à vapoter
Alors que l’appareil est verrouillé, maintenez
le bouton d’alimentation enfoncé et inhalez à
travers le Embout buccal. Relâchez le bouton
d’alimentation et expirez le nuage de vapeur.
CONSIGNES D’UTILISATION