Verco Kurt Booth User manual

Chapel Lane, High Wycombe, Buckinghamshire HP12 4BG
t: [phone] w: verco.co.uk
DOC ID: AI_0064
Step 1
The Booth assembly consists of two assembled
end frames, three linking rails, link curtain and
fixing screws.
Stand the assembled end frames in position
using a linking rail for distance in the room to
check positioning before assembly.
Step 2
Remove the two bolts and washers for the mid-
dle linking rail on both end frames. Discarding
the washers.
Step 3
Using the removed bolts, connect the middle
linking rail to both end frames.
Step 4
Remove the bolts and washers for the top link-
ing rail on the uprights, discard the washers.
Secure the top rail to one end frame.
Step 5
Thread the top* of the curtain along the top
rail, and secure the rail to the other end frame.
Check the rail is visible on the inside of the
booth. See below.
* the top Loop on the curtain is smaller than
the bottom loop

Chapel Lane, High Wycombe, Buckinghamshire HP12 4BG
t: [phone] w: verco.co.uk
DOC ID: AI_0064
Step 6
Thread the bottom linking rail through the bot-
tom of the curtain.
Step 7
Undo the bottom bolts and washers to one
end frame. Fix the bottom linking rail in place,
using the bolts, discard the washers.
Step 8
Rotate the rear seat fixing brackets and posi-
tion the seat so they align with the rear up-
rights. Then rotate the side seat brackets to
align with the adjacent uprights
Using the supplied screws, attached the seat
brackets to the uprights.
Secure seat brackets to the seat once fixed in
location.
Step 9
Draw the curtains long the rails to enclose the
booth.
Fix the other end of the bottom rail to the other
end frame assembly in the same method.
Kurt Booth Assembly Instructions