Verco VISUAL Desking VSST1020 User manual

1. ASSEMBLE CABINET ON LH
SIDE AS PER DIAGRAMS.
SCREW ALL METAL DOWELS
INTO HOLES IN TOP AND
LOCATE TOP ONTO LH END.
2. TIGHTEN EACH
CAM WITH A SCREW
DRIVER
3. LOCATE WOODEN
DOWELS IN END OF
INTERNAL SPACER
PANEL INTO HOLES
IN TOP. CHIPBOARD
EDGE TO FACE REAR
OF CABINET.
VISUAL Desking
VSST1020 tambour unit assembly instructions
Note: Instructions below show assembly of desk high tambour, use same methods and steps for taller
units.
4. PLACE BOTTOM INTO
POSITION AND LOCATE
WOODEN DOWELS IN
END OF INTERNAL
SPACER PANEL INTO
HOLES IN BOTTOM.
5. SECURE BOTTOM IN
PLACE BY SCREWING
BRACKETS TO END
PANEL USING HOLES
PROVIDED.
SHEET 1
NOTE: 2M UNITS
WILL HAVE A METAL
STRENGHTENING
RAIL SCREWED
HERE.
6 METAL
DOWELS
IN TOP
INTERNAL SPACER
PANEL
SPACER PANEL
ASSEMBLED IN PLACE
REAR EDGE BARE
CHIPBOARD

6. SLIDE INTERNAL
BACK PANEL INTO
INNER GROOVES.
8. SLIDE
TAMBOUR INTO
PLASTIC
CHANNEL.
9. PLACE RIGHT HAND END
ONTO CONSTRUCTION
LOCATING METAL DOWELS
IN TOP INTO HOLES IN END
OF RH PANEL. TIGHTEN
CAMS ON INSIDE FACE OF
RH END.
10. TIGHTEN CAM ON
REAR OF CABINET
7. SECURE INNER BACK
PANEL TO BACK EDGE
OF INTERNAL SPACER
PANEL WITH SCREWS
PROVIDED.
SHEET 2

11. SCREW BOTTOM
TO RH END USING
BRACKETS AND
HOLES PROVIDED.
12. SLIDE BACK
PANEL INTO
GROOVE IN BACK OF
CABINET.
13. SCREW BACK PANEL TO
EDGE OF BOTTOM PANEL
USING HOLES PROVIDED.
14. YOUR CABINET CAN NOW
BE UPTURNED INTO ITS
CORRECT POSITION.
SHEET 3