Vingtor Stentofon ECPIR-3P User manual

Replacing Access Panel ECPIR
Item Number
Item Name
Description
102 3200 030
ECPIR-P
Exigo Access Panel, PTT Button
102 3200 033
ECPIR-3P
Exigo Access Panel, PTT + 3 Buttons
1 Demounting the Old Access Panel
To demount the access panel:
1. Disconnect the access panel from the power supply, microphone, I/O interface and network
cables.
2. Remove the four screws that attach the access panel to the mounting box or console.
3. Lift the access panel out of the mounting box or console.
2 Mounting the New Access Panel
To mount the access panel:
1. Insert the access panel into the mounting box or console.
2. Fasten the access panel to the mounting box or console with the four screws.
3. Reconnect the access panel to the power supply, microphone, I/O interface and network cables.

3 Setting Up the New Access Panel
To set up the access panel:
1. Power up the access panel by connecting it to a PoE network.
2. Wait for the yellow Fault LED to start flashing, indicating that the access panel has been
booted up successfully.
3. Press any button to make the access panel speak its IP address.
4. Access the IP address through a web browser on a PC that is connected to the same network as
that of the access panel.
5. Log in with username: admin and password: alphaadmin
6. Select Station Main > Main Settings
7. Change the Domain Controller IP address, Directory Number, IP-address, Subnet-mask,
and Gateway to ones specified for the project.
8. Click Save
A100K11607
11611
DOC NO.
[email protected]