
10
CONTROLLER
OPERATING INSTRUCTIONS: When the system is powered on, the existing desktop height will
appear on the control panel.
Power-Saving Mode
When no actions are made for over 10 seconds, the system will enter power-saving mode. Touch
any button to enter operation mode.
Function Mode
Press and hold the “S” button for 3 seconds, or until “S - -” begins flashing on the display. Press
“S” again to enter Function mode. Within function mode, use the up and down buttons to scroll
through settings, and use the “S” button to select options. If no action is taken for 20 seconds, the
desk will return to operating mode.
• Change Displayed Unit (Un): Press the up or down buttons until the display
shows “Un”, and press “S” to select. Press up or down to select “SI” (metric) or “In”
(imperial). Hold “S” for 2 seconds to save the setting.
• Change Brightness (br): Press the up or down buttons until the display shows “br”,
and press “S” to select. Press up or down to select Low (L), Normal (n) or High (H)
brightness. Hold “S” for 2 seconds to save the setting.
• Collision Force Detection (CF): Press the up or down buttons until the display
shows “CF”, and press “S” to select. Press up or down to select “OFF”, Low (L), Normal
(n) or Heavy (H) collision force detection. Hold “S” for 2 seconds to save the setting.
Reset Mode
While the unit is powered on, press the down arrow until the desk moves to the fully lowered
position. Press and hold the down arrow for 5 seconds or until “rES” is displayed to enter reset
mode. Continue holding the down arrow, and the desk will move down to the lowest possible
height and then move back up slightly. The desk will then return to operating mode.
Up Arrow
Press and hold for continuous
upward movement. Short press
for 0.39"/1cm movement.
Sitting Height Preset
Aer programming preset,
press once for desk to return to
programed height.
Sitting Height Preset
Aer programming preset,
press once for desk to return to
programed height.
Set
Press once and then select one
of two memory preset buttons to
save the height.
Down Arrow
Press and hold for continuous
downward movement. Short press
for 0.39"/1cm movement.