Vivo STAND-V012M User manual

   
 
Instruction Manual
Email: [email protected]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
-  
 
phillips screwdriver
 
1
Scan the QR code with your mobile device or follow the link
to helpful videos and specifications related to this product.
 (x1)
Arms
(x1)
Lower Pole
 (x1)
Upper Pole
 (x1)
“ C Clamp
 (x1)
Gromme Base
! (x1)
Pole Connecor
" (x1)
Cable Clip
# (x1)
Plasic Cover
$ (x5)
Rubber Pa
% (x1)
Suppor Plae
& (x1)
3mm Allen
Wrench
' (x1)
5mm Allen
Wrench
 (x1)
6mm Allen
Wrench
- -()**++ ,-*)* +-
-  (x8)
M8x20
-  (x8)
M5x14
-  (x8)
M6x14

) 
) .
Screw pole adapter (F) onto pole (B). Slide one cable
management clip (G) onto pole (C). Screw pole (C) into
pole adapter (F). Use 3mm allen wrench (K) to tighten. Use
3mm allen wrench (K) to adjust height of stopper as
desired.
Place arm (A) onto pole (C). Tighten with mm allen wrench (L).
-/0 )
2
) 
1)  23 -) $
1)  2"--  $
Screw lower pole (B) into clamp base (D), and tighten the two set
screws with 3mm Allen Wrench (K). Apply pads (I) to bottom of clamp
base. Attach cover (H) and cable clip (G) to base and pole assembly.
Secure clamp to desk using hand bolt.
Remove Hand bolt from clamp (D) by first
removing Phillips Screw from the top of the
bolt, then remove the plate and unscrew the
bolt. Apply pads (I) to bottom of grommet base
(E). Screw lower pole (B) into base, and tighten
the two set screws with 3mm Allen wrench (K).
Attach cover (H) and cable clip (G) to base and
pole assembly. Mount grommet base to desk
using support plate (J) and previously removed
hand bolt.

) 4
) 5
Adjust monitor tilt angle using 6mm allen
wrench (M) as shown in diagram.
Store allen wrenches (M, L) as shown in
diagram.
) 6
Insert screw (M-A or M-B) and washer (M-C) into top two holes on
each monitor. Leave screw slightly loosened. Slide monitors onto
VESA plates as shown in diagram. Insert screw (M-A or M-B) and
washer (M-C) into bottom two holes on each monitor. Tighten all
screws.
3

If you do not understand these directions, or if you have any
doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no
missing or defective parts. Improper installation may cause
damage or serious injury. Do not use this product for any
purpose that is not explicitly specified in this manual. We
cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please contact
us. We are happy to replace parts to ensure you have a fully
functioning product.
70 8
  
Last updated: 0 /30/18
9  
4