Volt VSSI-2005-50-BK User manual

VOLT®Solar Landscape Lighting
VOLT®Solar Bistro String Lights (50ft)
VSSI-2005-50-BK
INSTALLATION INSTRUCTIONS
Specications and product details subject to change without notice.
© Copyright 2021, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3700
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
- 1 -

Important: Please Read Before Installation
INSTALLATION INSTRUCTIONS
!
www.voltlighting.com
Important Safety Instructions
!
- 2 -
VOLT®Solar Bistro String Lights (50ft)
VSSI-2005-50-BK
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
Please note that these solar xtures are equipped with built-in photocells, so
they will not turn on until it is dark enough. These xtures will also require
plenty of sunlight to function properly. It’s best to place the xture in an
area where the sun will get to it through out the day and where no ambient
lighting will affect the photocell at night. If your xture is not functioning
at night, be sure that the on/off button has been engaged. See step one for
details.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Lamp gets HOT quickly!
2. Do not touch the hot lens, guard or enclosure.
3. Keep lamp away from materials that may burn.
4. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
5. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS

[email protected] • 813.978.3700
- 3 -
Product Dimensions
Package Contents
Parts Required (Sold Separately)
A. (1) Guide Wire
A. (1) Solar Panel
B. (1) Support Arm
C. (1) Clamp with Support Arm
D. (1) Bistro String (50 feet
long)
E. (32) Bulbs (2 replacement
bulbs are included)
F. (1) Stake
G. (4) Straps
H. (4) Screws
I. (4) Wall Anchors
11.6”
50 Feet
2 Feet
SOLAR PANEL
BISTRO STRING
8”
1.5”

INSTALLATION INSTRUCTIONS
www.voltlighting.com
- 4 -
1
VOLT®Solar Bistro String Lights (50ft)
VSSI-2005-50-BK
Follow 1 of the 4 Solar Panel Mounting Methods
Method 1: Clamp Mount
Mount Clamp with Support Arm
Attach the clamp onto the side of the mounting surface.
Then go to the Installing Solar Panel and Bistro String steps.
Mounting Surface
Clamp
Clamp
Support Arm
Mounting Surface

[email protected] • 813.978.3700
- 5 -
1
Method 2: Surface Mount
Surface Mount
Place the support arm onto the
surface and mark points using
the holes as a guide. Then, drill
proper holes for the wall anchors
to be inserted.
Attach the support arm onto the
surface using the screws. Make
sure the screws are tightened
with a screwdriver to secure the
support arm.
Then go to the Installing Solar
Panel and Bistro String steps.
Wall Anchor
Mark
Support Arm
Screw
MOUNT SURFACE

INSTALLATION INSTRUCTIONS
www.voltlighting.com
- 6 -
Insert Straps
Method 3: Straps Mount
1
Tie the Strap
2
VOLT®Solar Bistro String Lights (50ft)
VSSI-2005-50-BK
Pass the ends of the strap through
two holes on the support arm.
Strap
Support Arm
Install the support arm by
wrapping the strap around the
desired tree or post. Insert the
pointed end of the strap into
the opposite end of the strap
and pull it through to tighten
the support arm onto the tree
or post.
Then go to the Installing Solar
Panel and Bistro String steps.
Strap
Strap End
Support Arm
TREE or POST

Insert Stake to Ground
2
[email protected] • 813.978.3700
- 7 -
Install Stake to Support Arm
Method 4: Stake Mount
1
Insert the top end of the stake
into the base of support arm.
Stake
Support Arm
Insert the stake into the ground.
Then go to the Installing Solar
Panel and Bistro String steps.
Support Arm
Ground
Stake

INSTALLATION INSTRUCTIONS
www.voltlighting.com
- 8 -
3
2
1
Install Solar Panel and Bistro String
VOLT®Solar Bistro String Lights (50ft)
VSSI-2005-50-BK
Remove Wire Cover
Twist and remove the wire
cover from the solar panel.
Wire Cover
Solar Panel
Wire
Connect Wires
Wire
Wire
Cap
Solar Panel
Bistro String
Connect the wire from bistro
string to the wire from the solar
panel. Tighten cords together by
using the cap on the wire from
the bistro string.
Install One Bulb to Test
Thread one bulb onto one
socket and tighten gently.
Bulb
Socket

Install Bistro String
6
Insert Stake to Ground
5
[email protected] • 813.978.3700
- 9 -
Test Solar Panel
4
Place the solar panel onto a at
opaque working surface. Press
the ON/OFF switch on the back of
the solar panel to test the light
source. The light will turn on
while the switch is on.
Now you can proceed to next
steps of installations knowing the
xture is in ON mode.
On/Off Switch
BACK
FLAT SURFACE
Solar Panel
Insert the attachment piece on
the back of the solar panel onto
the holder on the top end of the
support arm.
Support Arm
Solar Panel
Holder
Attachment piece
Pass the guide wire through the holes on the top end of the sockets
and then x the guide wire to your desired location or tie the bistro
string to applicable locations directly.
Socket
Guide Wire
Bistro String

INSTALLATION INSTRUCTIONS
www.voltlighting.com
- 10 -
Final Adjustment
8
7
VOLT®Solar Bistro String Lights (50ft)
VSSI-2005-50-BK
Install Remaining Bulbs
Thread bulbs onto the sockets
and tighten gently.
Bulb
Socket
Screw
Solar Panel
ROTATE Loosen the screw at the knuckle
to adjust the solar panel to make
sure it can get plenty of sunlight.
Then tighten the screw to secure
the solar panel placement.