Von Duprin 230L-BE User manual


24743411
1 Change handing if required (see instructions on next page).
2 Install cylinder (L lever control only).
Mortise cylinder with
standard straight cam
in position shown with
key removed
Cylinder collar
Lock
nut
3 Install tailpiece. Consult factory for doors other than 1-3/4” or
2-1/4” thick.
Pine tree clip
Tailpiece
Use this hole for
2-1/4" thick door
Use this hole for
1-3/4" thick door
4 Install tailpiece guide in exit device cam.
Tailpiece guide
Exit device cam
5 Prepare door for lever control installation.
1. Center lines correspond
to center lines on exit
device instructions.
2. See exit device
instructions for cutouts
on inside of door.
NOTES
!
5/8”
5/8” diameter
3/8” dia.
4 places
1-11/16”
1-1/4”
C
L
1-11/16”
C
L
6 Install lever control.
LHR RHR
!NOTE:
See exit device
instructions for
additional information.
Lever Control
230L/L-BE
Installation Instructions

© Allegion 2014
Printed in U.S.A.
24743411 Rev.02/14-a
To Change Handing or Replace Broken Shear Pin
1 Check lever position (Figure 1).
1a To change handing or replace broken shear pin,
complete Steps 2 through 7.
Figure1
!NOTE:
The replaceable shear pin
breaks to protect the assembly
from damage when excessive
torque is applied.
Lever in
LHR
position
Lever in
RHR
position
2 Remove lever cam.
2a Remove snap ring and wave spring washer.
2b Use screwdriver to push up on slider leg to remove
preload from lever cam and remove lever cam.
Wave spring
washer
Snap
ring
Lever
cam
Slider leg
!CAUTION:
Do not remove
back plate.
Back plate
3 Remove shear pin. If shear pin is broken, make sure
to remove all pieces of broken shear pin.
Shear pin
Loosen set screw enough
to allow shear pin to slide
out.
4 Rotate lever to LHR or RHR position (Figure 1).
5 Install shear pin.
Reinstall shear pin
and tighten set screw
6 Install lever cam with correct handing.
RHRLHR
"L" is visible for LHR
7 Reinstall wave spring washer and snap ring.
Customer Service
1-877-671-7011 www.allegion.com/us