Vulcan-Hart GL40 User manual

Item # __________________________
C.S.I. Section 11420
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. [phone]
502-778-2791 QUOTE & ORDER FAX: [phone]
A2780
ISO9001
Vulcan-Hart Co.
F-31643 (07-07)
GL40 40 gallons 151 liters
GS60 60 gallons 227 liters
GL80 80 gallons 303 liters
GT100 100 gallons 379 liters
GT125 125 gallons 473 liters
GT150 150 gallons 568 liters
SPECIFICATIONS:
Gas fully jacketed stationary kettle, Vulcan Model No. ________.
Kettle is mounted on 2" diameter legs with adjustable flanged
feet. Cover to be stainless steel dome shaped with drop type
handle and insulated knob. The dish shaped interior bottom is
sloped to the front for a smooth product flow through a mounted,
tapered, 2" plug type food product draw-off valve. Draw-off
includes opening strainer. Graduated measuring rod. Furnished
standard with a 15 PSI relief valve, vacuum relief valve, thermo-
stat with a combination gas control valve and electronic ignition,
low water cut-off control and a pressure limit switch and pressure
gauge.
CSA design certified. Classified by U L to NSF Std. #4. Meets
ASME code.
GS, GL, GT SERIES
GAS FULLY JACKETED KETTLE
MODELS: GS, GL, GT SERIES Gas Fully Jacketed Kettle
STANDARD FEATURES
■Kettle fully steam jacketed.
■Mounted on stainless steel 2" diameter legs with adjustable
flange feet.
■Stainless steel dome shaped spring assist cover with drop type
handle.
■Kettle interior bottom sloped to front for smooth product flow
through a mounted, tapered, plug type food product draw-off
valve of standard 2" diameter.
■Draw-off opening strainer.
■Graduated measuring rod.
■15 PSI relief valve.
■Vacuum pressure relief valve.
■Thermostat with a combination gas control valve and elec-
tronic ignition.
■Low water cut-off control.
■Pressure limit switch and pressure gauge.
■Faucet bracket.
■One year limited parts and labor warranty.
OPTIONS
■■3" compression type draw-off valve in place of 2".
■■Change in leg height to increase clearance under draw-off
valve.
■■Condensate ring on cover hinges.
■■Swing drain collector.
■■316 stainless steel jacket liner
■■Second year extended limited parts and labor warranty.
ACCESSORIES
■■Stainless steel draw-off extension tube.
■■(12") (18" double jointed) single pantry faucet.
■■(12") (18" double jointed) double pantry faucet.
■■Double pantry washdown hose with 16" add-on faucet with
backflow preventer.
■■Double pantry washdown hose with backflow preventer.
■■Double pantry pot filler and backflow preventer.
■■Rotating tri-basket assembly.
■■Clean-up kit to include draw-off brush, clean-up brush with
36" handle and paddle scraper with 40" handle.
■■48" stainless steel whip.

Printed On Recycled Paper
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. [phone]
502-778-2791 QUOTE & ORDER FAX: [phone]
NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specifications without notice.
F-31643 (07-07)
GS, GL, GT SERIES
GAS FULLY JACKETED KETTLES
SERVICE CONNECTIONS:
Gas Supply: 3/4" NPT, 6" AFF, Volume per schedule.
Electric Connection: 120-1 Circuit, 0.3 KW, 16 AFF.
Water: Faucet location.
NOTE:
•Dimensions which locate the above connections have a tolerance of +
or -3" (+ or -75 mm).
•Installation of backflow preventers, vacuum breakers and other specific
code requirements is the responsibility of the owner and installer. It is
the responsibility of the owner and installer to comply with local codes.
•Plastic drains are not recommended due to inherent limited tempera-
tures of the plastic.
•This appliance is manufactured for commercial installation only and is
not intended for home use.
IMPORTANT:
1. A pressure regulator sized for this unit is included. Natural
gas 8.0" W.C. Propane 10.5" W.C.
2. Gas line connecting to unit must be 3/4" or larger. If flexible connectors
are used, the inside diameter must be at least the same as the 3/4" iron
pipe and rated for the correct gas input.
3. Requires 120 volt, 60 Hz, 1 phase electrical connection. 3 amp total
draw.
4. An adequate ventilation system is required for commercial cooking
equipment. Information may be obtained by writing to the National
Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
When writing refer to NFPA No. 96.
5. These units are manufactured for installation in accordance with
ANSZ223.1a (latest edition), National Fuel Gas Code. Copies may be
obtained from the American Gas Association. 1515 Wilson Blvd.,
Arlington, VA 22209.
6. Equipment Clearance: Combustible Non-Combustible
Rear 2" 0"
Right 0" 0"
Left 0" 0"
BRIMFUL CAPACITIES:
Model Gallons Quarts Liters 4 oz. svgs.
GL40 40 160 152 1280
GS60 60 240 227 1920
GL80 80 320 303 2560
GT100 100 400 379 3200
GT125 125 500 473 4000
GT150 150 600 568 4800
MODEL CAPACITY A B C D E F G BTU/hr. INPUT
GL40 40 gal., 151 liters 29 (737) 48 (1219) 41 (1041) 38 (965) 14 (356) 40 (1016) 71 (1803) 105,000
GS60 60 gal., 227 liters 36
1
/ 2 (927) 58
1
/ 2 (1486) 48 (1219) 44 (1118) 17 (432) 39 (991) 78 (1981) 135,000
GL80 80 gal., 303 liters 36
1
/ 2 (927) 58
1
/ 2 (1486) 48 (1219) 44 (1118) 17 (432) 44 (1118) 83 (2108) 135,000
GT100 100 gal., 379 liters 36
1
/ 2 (927) 58
1
/ 2 (1486) 48 (1219) 44 (1118) 17 (432) 49 (1245) 88 (2235) 135,000
GT125 125 gal., 473 liters 36
1
/ 2 (927) 58
1
/ 2 (1486) 48 (1219) 44 (1118) 17 (432) 56 (1422) 95 (2413) 135,000
GT150 150 gal., 568 liters 36
1
/ 2 (927) 58
1
/ 2 (1486) 48 (1219) 44 (1118) 17 (432) 62
1
/ 2 (1587) 101 (2565) 135,000