Waykar PD08E User manual

Home Dehumidifier
Please read the manual carefully
before using the unit
PD08E
USER MANUAL

Thank you for purchasing our dehumidifier.
Waykar wishes that our products and services can bring convenience to your
work and life.We highly recommend that you keep the manual for reference if
you encounter unexpected events using the unit.
Please read the manual carefully to ensure proper use of the dehumidifier.
Our dehumidifiers are widely used in family bedrooms, bathrooms,
basements, offices and storage rooms, etc.
The dehumidifiers from provide quick and efficient operation to Waykar
reduce room's humidity and bring you a healthy and comfortable life.
If there is any problem of the product, please contact Waykar Customer
Service at with your Purchase Order ID to help you [e-mail]
address the problem more effectively.
FOR CUSTOMERS
TO ACCESS CUSTOMER SUPPORT FASTER

To prevent any internal damage, it is very important to
keep refrigeration units (like this one) upright throughout
their journey.
Please leave it standing upright and outside the box for
24 HOURS before plugging it in.
BEFORE FIRST USE:

Safety Instructions
TABLE OF CONTENTS
Common Faults and Solutions
The graphics and functions provided in this manual may not be the same as the
actual product. Please always refer to the actual product.
The model of the machine on the manual is for reference only. Please check the
corresponding content and operate the machine based on the actual product.
The right to interpret the relevant terms belongs to the company.

For your safety, please read the manual carefully and keep the manual before
you use the manual for reference.
Please use this product according to the instructions of installation and
operation of this manual.
Before cleaning the dehumidifier, turn off the power and unplug it from the power
outlet.
Please do not place the machine near any heat source or flammable goods.
Always keep the machine on even surface, instead of placing on uneven or
slopping ground.
When the power cord is damaged, it must be replaced by the qualified technician
approved by our company.
When using the dry clothes function, the clothes should be kept at least 40cm away
from the air to prevent water from entering the outlet and damage the machine.
The machine power wiring must be in accordance with national wiring rules, and,
power line should be connected to the reliable external Earth Line.
The fixed wiring of the machine connection must be equipped with an all-pole
disconnect device (air switch) with at least 0.118-inch distance of electric shock.
This appliance can not be used by children aged under 8 years old and persons
withreduced physical, sensory or mental capabilities or lack of experience and
knowledge unless they have been given supervision
or instructions concerning use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children without supervision.
When using dehumidifier, other objects
surrounding the machine need to be kept at
least a distance of 7.9 inches (20cm) as shown
in the picture on the right:
Safety Notes:
SAFETY INSTRUCTIONS

Water Tank
Drainage Outlet

WATER FULL Indicator
1. Control Panel
To set auto ON/OFF timer in 1-24 hrs.
Indicates the water tank is full.

Setting Humidity
The humidity level can be set within a range of 30%RH to 80%RH in 5%
increments.
-When it starts to work, it will first automatically detect and show the room's
humidity. Press the "SETTING" button to change the humidity selection in 5%
increments. " " will Flash and show the setting humidity.88
-Press "SETTING" to make the humidity increase OR decrease by 5%RH.
-After no operation for 5s, " " will show the actual room humidity.88
-When the humidity level is higher or drops to the level you have set, the
dehumidifier will automatically begin to work or stop.
-When the humidity level is set at 30%RH, the dehumidifier will work at
continuous dehumidifying mode.
2.Setting
Child Lock Setting
This TIMER setting function is designed for you to set a time to turn off or turn on
the machine, automatically by the timer.
1. Press the "TIMER" button to select the timer by 1-hour increment. You can set
the timer up to24 hours. It will start to do the countdown when you start the timer.
2. Press and hold the "TIMER" button for several seconds to make the selection
of the timer faster.
3. If the time is set to 00, this is called the invalid time. If you set the timer
successfully, the light "TIMER" will be up. The LED screen will show the
remaining time if you press the"TIMER" button, and display the current humidity
automatically after a few seconds.

Control the fan speed. Press to select either High or Normal fan speed.
Higher fan speed will result in quicker moisture removal. Set the speed high
for maximum moisture removal. When the humidity has been reduced and
quiet operation is more preferred, set the fan speed back to Normal.
Note: In the DRY mode, the SETTING button and the SPEED button is disabled.
Press the " " button until you see the CONT indicator light up on the
display to select continuous mode. In CONT mode, the dehumidifier will run
continuously until the water tank is full.
When the water tank is full of water, the machine will turn off automatically.
The indicator light " " will flash. After you empty the water from the water
tank, the indicator light " " will turn off. The machine will restart to work.
Caution:
Water tank must be placed in right position, otherwise will cause the
water full alarm.
Convenient Drainage
Auto Drainage: The dehumidifier has continuous drainage outlet where you
can just simply attach the 6.56 ft. hose for continuous draining.
Manual Drainage: When the water tank is full, the "Full Tank" indicator will
light up, the dehumidifier will automatically switch off and will start to turn on
automatically when the tank is emptied and placed back to the unit.
“ "

Auto Shut-off
When the water tank is full and or the room humidity reaches the setting
value, the dehumidifier will stop working automatically.
3 Minutes Delay Protection
The compressor features the "3 minutes delay protection" function— When
the dehumidifier is powered, the compressor can only start again 3 minutes
after its last shutdown.
Auto Defrost
When the dehumidifier is running at a lower temperature, the system will
automatically determine whether there is a presence of frost. If any frost
exists, it will defrost automatically.
The fan will runs at high wind speed and the compressor will stop.
During the defrosting process, the POWER indicator will flash.
Auto Restart
If the dehumidifier shut off unexpectedly due to the power outage while it's
running or in standby mode, the dehumidifier will restart with the previous
function setting (working mode, setting humidity value and fan speed, etc.)
automatically when the power resumes.
More Functions

High-speed indicator light " ": If you set the unit to high speed fan mode,
the indicator will light up.
Water full light indicator " " When the water tank is full, this indicator
will flash.
3. Display Status Description
When the device is currently powered on, before switching on the
machine for further operations, only the power button light up.
Setting light " "If the timer is set up properly, the indicator light will be
up, flash if press TIMER button again to check and reset, and go out if
non-successful setup.
Low-speed indicator light " ": If you set the unit to low speed fan mode,
the indicator will light up.
Dehumidification light " ": When the machine starts to dehumidify, the
indicator light will be on.
When the dehumidifier normally works, " " will show the current humidity.8 8
4. Instructions for Drying Clothes
Note: Keep away the unit from the water drips of the washed clothes.
Open the dehumidifier and set the humidity level at 30%RH. It is best if you
let the air outlet of the dehumidifier to blow air to the clothes directly.
2. The drying effect will vary from the thickness of clothes, the number of
clothes and the size of the drying space. Theoretically, the effect will be
better when clothes are few, thin and space is small.
3. The drying process would take 3-8 hours, and we suggest that continuous
drainage mode would be more suitable when drying clothes.

Fault Phenomenon Analysis of Causes Processing Method
Humidity sensor failure?
Set the humidity to 30%RH, the
dehumidifier can still continue to
work, and can be used normally.
Repair and replace the humidity
sensor.
1. Water on the surface
of the humidity sensor?
2.Humidity sensor failure?
The dehumidifier is not affected
and can continue to work, and
can be used normally.
Repair and replace the humidity
sensor.
Please let the dehumidifier keep
working for a period of time,
after the water on the surface of
humidity sensor is removed, it
will return to normal.
contact Waykar
Customer Service at for [e-mail]
5. Faults & Processing Methods
Humidity always shows
"25%RH"(There is a big
difference from the actual
humidity)
Humidity always shows
"99%RH"(There is a big
difference from the actual
humidity)

6. Empty The Water Tank
Two ways are available to remove the collected water.
Use The Water Tank
When the water tank is already full, the WATER FULL indicator will light
up, the dehumidifier will automatically shut down until the tank has
been emptied and placed back to the unit.
Pull the water tank out from
the bottom with both of your
hands.
Open the cover of the water
tank. Empty the water tank.
Put the water tank back in
place, the water full indicator
will go out.

Take off the water
tank cover
Note:

Pull out the power supply, unscrew the drainage cap, remove the black
rubber plug, insert the water hose into the continuous drainage port and push
it back into the water tank.
Connect the power supply to start the operation. The water outlet of the water
hose should be lower than the continuous drainage port by more than 3.9
inches, and the water hose cannot be bent.
(Note: The diameter of continuous drainage port is 0.63 inches.)
7.Continuous Drainage
Drainage Cap
Unscrew the drainage
outlet cap
Remove the Black Rubber
Plug
Insert the water hose into the
continuous drainage port.
3

Please use a soft and slightly wet textile or cloth to clean it.
3.Slowly insert the filter back to the machine body.

The list includes most of the common cases, but not the results of defective
unit, crafts or materials in the unit.
If all troubleshooting steps have been exhausted and the issue is still
occurring, please feel free to reach out to Waykar Customer Seryice to get
further assistance.
Is the Full Tank indicator blinking?
This product does not apply to
over hot or cold environment, the
machine will automatically enter
the protection mode. It is a normal
phenomenon.
When running under lower
ambient temperature, the machine
will automatically defrost, which is
a normal phenomenon. It will
restart dehumification again until
the defrosting process finished.
It is normal the compressor
ceases while defrosting process.
Wait until the process finished, it
will restart dehumidification again.
Is the room humidity lower or
reaching the preset humidity
level?
(When the room humidity has
reached the preset level, the
dehumidifier will enter Standby
Mode and the indicator on LCD
will flash. )
Please set the humidity 5%RH
lower than the room humidity or
set the humidity to 30%RH.
This is to prevent the frequent
start of the machine. Does the
machine stop working just now?
The dehumidifier is designed to
work in the humidity range of 30%-
80%. Above or below this range, it
will not work.
, it

Room temperature is too low, or
below 41℉ (5℃): The machine
will not work or undergo poor
dehumifying efficiency in low
temperature.
Please wait until the temperature
rises to above 41℉ (5℃) or higher.
Clean up the dirt or lint on the air
outlet and intake.
Continuous Mode
Do Not set the humidity too low.
Typically, 40-50% are good for
use.
Please check whether the packing
bag of the filter had been removed
and the filter has been installed
correctly.
The
to
to
levelly.
Please leave about 20cm (7.9
inches) around the product.
Do not allow enough time to
remove the moisture.

Connect the hose with the
drainage port tightly.
The water tank has not been
installed properly.
The float of water tank has been
stuck.
Re-install the water tank properly.
Move the float and let it swing
freely.
If the dehumidifier is still not working properly as expected and the
troubleshooting steps or solutions above may not resolve the issue,
please unplug the power and shut down the dehumidifier, then contact
Waykar Customer Service at . [e-mail]