Waykar PD253B User manual

Home Dehumidifier
Please read the manual carefully
before using the unit
PD253B
USER MANUAL

Thank you for purchasing our dehumidifier.
Waykar wishes that our products and services can bring convenience to your
work and life.We highly recommend that you keep the manual for reference if
you encounter unexpected events using the unit.
Please read the manual carefully to ensure proper use of the dehumidifier.
Our dehumidifiers are widely used in family bedrooms, bathrooms,
basements, offices and storage rooms, etc.
The dehumidifiers from provide quick and efficient operation to Waykar
reduce room's humidity and bring you a healthy and comfortable life.
If there is any problem of the product, please contact Waykar Customer
Service at with your Purchase Order ID to help you [e-mail]
address the problem more effectively.
FOR CUSTOMERS
TO ACCESS CUSTOMER SUPPORT FASTER

To prevent any internal damage, it is very important to keep the unit
(like this one) upright throughout its journey.
Please leave it standing as the picture shown below and outside the
box for before plugging it in.24 HOURS
BEFORE FIRST USE:

The graphics and functions provided in this manual may not be the same as the
actual product. Please always refer to the actual product.
The model of the machine on the manual is for reference only. Please check the
corresponding content and operate the machine based on the actual product.
The right to interpret the relevant terms belongs to the company.
Common Faults and Solutions
TABLE OF CONTENTS
Safety Instructions

For your safety, please read the manual carefully and keep the manual before
you use the manual for reference.
Please use this product according to the instructions of installation and
operation of this manual.
Before cleaning the dehumidifier, turn off the power and unplug it from the power
outlet.
Please do not place the machine near any heat source or flammable goods.
Always keep the machine on even surface, instead of placing on uneven or
slopping ground.
When the power cord is damaged, it must be replaced by the qualified technician
approved by our company.
When using the dry clothes function, the clothes should be kept at least 40cm away
from the air to prevent water from entering the outlet and damage the machine.
The machine power wiring must be in accordance with national wiring rules, and,
power line should be connected to the reliable external Earth Line.
The fixed wiring of the machine connection must be equipped with an all-pole
disconnect device (air switch) with at least 0.118-inch distance of electric shock.
This appliance can not be used by children aged under 8 years old and persons
withreduced physical, sensory or mental capabilities or lack of experience and
knowledge unless they have been given supervision
or instructions concerning use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children without supervision.
When using dehumidifier, other objects
surrounding the machine need to be kept at
least a distance of 7.9 inches (20cm) as shown
in the picture on the right:
SAFETY INSTRUCTIONS
Safety Notes:

Water Tank

Adjust the humidity level down
Adjust the humidity level up
Control the fan speed
Timer Button
Speed Button
Lighting Button
Control the LED panel to light
up or go out
1. Control Panel
Press to initiate the auto-start
and auto-stop feature
Lock (2s) Button
Press the button and hold for 2
seconds, the control panel will
be locked

88
88
After no operation for 5s,
2.Setting

Set the speed
high
When the humidity has been reduced
and quiet operation is more preferred, set the fan speed back to Normal.
keep the previous parameters of setup.
When the water tank is full of water,
tank
Caution:
Water tank must be placed in right position, otherwise will cause the water
full alarm.
When the unit is turned on, press "LOCK" and hold on for 2 seconds, the
control panel will be locked together with the other buttons. To unlock the
control panel, press and hold the "LOCK" button again for 2 seconds.
1. In the power on state, press the "Light" button to turn on or turn off the backlight;
2. When light funtion is powered on, except the "Power" button and the "Lighting"
button is on, other backlight indicators will be off.

will not be on.
If any frost exists,
When the device is currently powered on, before any operation, only the
"POWER" light will be up indicating the device is in "Standby" Status.
If the timer is set up properly, the indicator
light will be up, flash if press TIMER button again to check and reset, and
go out if non-successful setup.
If the lighting function is powered on, the light
button will be on, but other backlight indicators will be off.
High-speed indicator light
this indicator will light up.
Dehumidification light
the indicator light will be on.
machine
Water full indicator light When the water tank is full,
When the dehumidifier normally works, " " will show the current humidity.
88
Low-speed indicator light
this indicator will light up.
to
3. Display Status Description

4. Instructions for Drying Clothes
Step 1.
Hang the washed clothes in a small space such as cloakroom, bathroom,
or storage room.
Note: Keep away the unit from the water drips of the washed clothes.
Step 2.
Open the dehumidifier and set the humidity level at 30%RH. It's the best
if you let the air outlet of the dehumidifier to blow air to the clothes
directly.
2. The drying effect will vary from the thickness of clothes, the number of
clothes and the size of the drying space.Theoretically, the effect will be
better when clothes are few, thin and space is small.
3. The drying process would take 3-8 hours, and we suggest that
continuous drainage mode would be more suitable when drying clothes.
1. The dehumidifier can be used for drying clothes in rainy weather.

Fault Phenomenon Analysis of Causes Processing Method
Humidity sensor failure?
Set the humidity to 30%RH, the
dehumidifier can still continue to
work, and can be used normally.
Repair and replace the humidity
sensor.
1. Water on the surface
of the humidity sensor?
2.Humidity sensor failure?
The dehumidifier is not affected
and can continue to work, and
can be used normally.
Repair and replace the humidity
sensor.
Please let the dehumidifier keep
working for a period of time,
after the water on the surface of
humidity sensor is removed, it
will return to normal.
contact Waykar
Customer Service at for [e-mail]
5. Faults & Processing Methods
Humidity always shows
"25%RH"(There is a big
difference from the actual
humidity)
Humidity always shows
"99%RH"(There is a big
difference from the actual
humidity)

6. Empty The Water Tank
Two ways are available to remove the collected water.
Use The Water Tank
Pull the water tank out from
the bottom with both of your
hands.
Put the water tank back in
place, the water full indicator
will go out
When the water tank is already full, the WATER FULL indicator will light
up, the dehumidifier will automatically shut down until the tank has
been emptied and placed back to the unit.

Take off the cover
of water tank
Water tank
Do not remove the float from the water tank. If the float in the water tank is
removed, the sensor may not be able to determine the water level stored in
the tank properly that may lead to water overflow leak from the water tank.
If the water tank is dirty, just use cold water or warm water to clean it. Do not
use detergent, steel wool, chemically treated dust cloth, gasoline,benzene,
thinner or other solvents. Otherwise, it may damage the water tank and
cause it to leak.
When placing back the water tank, use your hands to press the tank back in
its place. If the water tank is not placed properly, sensors or protections
from water overflow may not operate as expected.
Note:

Pull out the power supply, take out the water tank, open the draining cap,
insert the water hose into the continuous drainage drainage port and put
back the water tank.
Connect the power supply to start the operation.The outlet of the water
hose should be lower than the continuous drainage port by more than 3.9
inches, and can not be bent.
(Note: The diameter of continuous drainage port is 0.63 inches. )
Open the drainage cap Insert the water hose into the
continuous drainage port
Continuous
Drainage Port
7.Continuous Drainage

Please use a soft and a slightly wet textile or cloth to clean it.
cleaning.
C-Dehumidifier storage
1.Pull out the filter.
2.Clean the filter: Use a vacuum cleaner to gently remove the dust from
the surface of the filter. If the filter is very dirty, clean it with warm water
and mild detergent and dry it completely.
3.Slowly insert the filter back into the machine body.

The list includes most of the common cases, but not the results of defective
unit, crafts or materials in the unit.
If all troubleshooting steps have been exhausted and the issue is still
occurring, please feel free to reach out to Waykar Customer Seryice to get
further assistance.
Is the Full Tank indicator blinking?
This product does not apply to
over hot or cold environment, the
machine will automatically enter
the protection mode. It is a normal
phenomenon.
When running under lower
ambient temperature, the machine
will automatically defrost, which is
a normal phenomenon. It will
restart dehumification again until
the defrosting process finished.
It is normal the compressor
ceases while defrosting process.
Wait until the process finished, it
will restart dehumidification again.
Is the room humidity lower or
reaching the preset humidity
level?
(When the room humidity has
reached the preset level, the
dehumidifier will enter Standby
Mode and the indicator on LCD
will flash. )
Please set the humidity decrease
by 5% than the room humidity or
set the humidity to 30%.
This is to prevent the frequent
start of the machine. Does the
machine stop working just now?
The dehumidifier is designed to
work in the humidity range of 30%-
80%. Above or below this range, it
will not work.
, it

product
Room temperature is too low, or
below 41℉ (5℃): The machine
will not work or undergo poor
dehumifying efficiency in low
temperature.
Please wait until the temperature
rises to above 5℃ or higher.
Clean up the dirt or lint on the air
outlet and intake.
Continuous Mode
Do Not set the humidity too low.
Typically, 40-50% are good for
use.
Please check whether the packing
bag of the filter had been removed
and the filter has been installed
correctly.
The
to
to
levelly.

Connect the hose with the
drainage port tightly.
The water tank has not been
installed properly.
The float of water tank has been
stuck.
Re-install the water tank properly.
Move the float and let it swing
freely.
If the dehumidifier is still not working properly as expected and the
troubleshooting steps or solutions above may not resolve the issue,
please unplug the power and shut down the dehumidifier, then contact
Waykar Customer Service at . [e-mail]

Do not insert thin rods and hard
objects into the machine body to
avoid malfunction and danger.
When cleaning the dehumidifier,
please use the wet textile to
wipe gently, do not shoot the
water directly.
Please clean the filter every two
weeks (do not use hot water
above 104°F, alcohol, gasoline
or toluene.)
When continuous drainage, the
drain hose must be placed
horizontally, without
unevenness and winding.
After cleaning the filter, please
do not dry it under direct
sunlight, in case deformation.