West Elm Brass Orbit Mirror User manual

P: 1 / 2
MOUNTING INSTRUCTIONS
For safety and ease of mounting, two people are recommended.
Handle carefully to avoiding scratches to both the item & the wall during the mounting.
HARDWARE ENCLOSED:
(A) Drywall Anchor x2
(B) Screw x2
TOOLS REQUIRED:
Phillips Screwdriver / Pencil / Tape Measure / Level / Stud-finder
Hanging Orientation Options:
Mounting Steps:
1. First, use a tape measure to measure the exact distance between
the two keyholes (measure from center to center of each keyhole,
as shown).
Record this measurement as “Distance A”.
2. With the back of the item facing away from the wall, hold the item
straightly at a desired mounting location.
Use a pencil to mark the wall on each side of the item and in
alignment with the two keyholes. Then set the item aside.
3. Connect the two marks of Step (2) with a light pencil line and use a level to ensure the line is level.
Make two "insertion marks" centered along this line with a measurement equal to “Distance A”.
3
Note: The hardware included with this item is meant
for drywall or stud mounting only. For other wall
types, please consult your local hardware store for
assistance in selecting the appropriate hardware.
B
A
1
2
Brass Orbit Mirror

P: 2 / 2
4. Use a stud-finder to determine if there is a wall stud located at either insertion mark, install the proper hardware.
For stud marks: Use a screwdriver to secure a screw directly into the wall remaining the screw head about 3/8 inch
from the wall.
For non stud marks: First install an anchor into the wall and then secure a screw into the anchor. Also, remain the
screw head 3/8 inch protruded from the wall.
5. Hang the item on the wall by engaging the appropriate two keyholes with the protruding screw heads.
CARE INSTRUCTIONS:
-To clean: wipe with a soft, dry or slight damp cloth.
-Do not use abrasive or strong chemical household cleaners.
Thank you for your purchase!
Stores | Catalog | www.westelm.com
How to install the anchor?
Place a Phillips screwdriver into the
recess of the anchor and firmly press
the anchor into the wall while turning
it clockwise until the anchor’s head
becomes flush with the wall surface.
3
4
A
B
B