Wildix W01 FXS User manual

4/20/2017
W01/02/04FXS – Quick Installation Guide
The steps below help you to connect and configure the W01FXS, W02FXS and W04FXS media gateways. FXS
gateway allows you to connect analog phones and fax machines to your IP PBX.
Updated: March 2017
Quick Overview
Connection to power supply (old models without PoE)
Connection to Ethernet
Connection to the line
Provisioning of the gateway
Assign analog ports
Reset of the gateway
Quick Overview
Rear panel
Reset button
Power supply jack
Input: AC100V~240V, 50/60Hz
Output: DC 12V, 1.5A (W04FXS) or 1A (W01FXS)
Network ports
2 Ethernet ports RJ-45, 10/100 base-T
1 WAN port
1 LAN port configured in Bridge
FXS ports
1, 2 or 4 FXS ports (depending on the model), to connect to analog phone
Front panel
1 Power LED indicates that the gateway is powered
1 Status LED indicates that the system is startup successfully
1 Proxy LED indicates that the gateway is registered on SIP proxy (W04FXS only)
1 LAN LED indicates that the gateway is connected to the network via this port
1 WAN LED indicates that the gateway is connected to the network via this port
Phone LED (1 for W01FXS and 4 for W04FXS) indicate that analog phones are connected:
flashing LED indicates an incoming call
LED is ON indicates that the connected phone’s handset is lifted or the phone is engaged in a
1/4

conversation
Connection to power supply (old models without PoE)
Connect the FXS gateway using the power supply and the cable provided with the gateway, as it is shown on the
picture.
Connection to Ethernet
The gateway has one LAN port configured in Bridge mode and one WAN port set up as a DHCP Client. Connect one
of two ports to the same network as the PBX or an external DHCP server (for instance, its router) as shown on the
picture.
As soon as the DHCP server assigns an IP address to the gateway, you can pass to the next step of the gateway
configuration.
In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
In case an external DHCP server is used, check the list of the active leases to detect the IP address assigned
to the gateway
Connection to the line
FXS gateways have 1 or 4 ports (depending on the model) on the rear panel, marked as Phone1-Phone4. Connect
the ports to the analog phones.
2/4

Provisioning of the gateway
Follow our online guide to provision the gateway.
For remote/unreachable media gateways behind NAT/Firewall, follow our online guide to remote provisioning.
Assign analog ports
Follow our online guide to assign the analog ports of the FXS gateway: https://manuals.wildix.com/wms-start-guide/
(Chapter 7.3)
Reset of the gateway
In case you need to reconfigure the FXS gateway, you should perform a reset procedure, as shown on the picture.
The switch marked as “Reset/Default” is situated on the rear panel of the gateway.
use the paper clip or the object of the similar shape to press the button
keep the button pressed for 5 seconds
when the LED Status turns on, the reset of the gateway is complete
3/4

4/4