Wildix W01GSM User manual

4/19/2017
W01GSM – Quick Installation Guide
W01GSM Quick Installation Guide helps you install and configure the GSM gateway. Thanks to GSM gateway it is
possible to send SMS using your Wildix PBX and to call mobile numbers using the GSM SIM card.
Updated: March 2017
min. WMS version required: 2.8.20131
Requirements
Overview and LED indicators
Installation and connection
Provisioning and configuration
Requirements
WMS version min. 2.8.20131
PoE switch
DHCP server
GSM SIM card with PIN disabled
If you are using a WMS integrated DHCP Server, go to WMS Settings → System → DHCP Server and search for
the device on the DHCP leases.
Note: the media gateway does not support VLAN.
Overview and LED indicators
LED indicator State Description
RUN ON device is booting
Slow blinking device is not registered
Fast blinking device is registered
GSM ON device is booting / call in progress
1/2

OFF SIM card is not registered / incorrect
PIN / no coverage
Slow blinking SIM card is registered
Interface Description
WAN WAN indicator blinks if device is connected even if it’s
not registered
RST Press and hold for over 6 seconds using a paper clip to
restore to the factory defaults
SIM slot Press the yellow button to open the card slot and insert
the SIM card
ANT 3dB external antenna
Installation and connection
Make sure the PIN code of the SIM card is disabled.
1. Screw the antenna into the ANT jack plug of the gateway (antenna with a longer cable is available as a
separate product: code: W01GSM-ANT)
2. Insert the SIM card (press the yellow button to make the SIM tray pop out)
3. Connect the WAN interface of the gateway to the PoE switch
Provisioning and configuration
Follow our online guide to provision the GSM gateway: https://manuals.wildix.com/provisioning-of-wildix-devices/
For remote/unreachable media gateways behind NAT/Firewall, follow our online guide to
remote provisioning: https://manuals.wildix.com/guide-to-remote-provisioning-of-wildix-devices/
Go to WMS > Trunks to edit the GSM gateway parameters: https://manuals.wildix.com/trunk-settings/#gsm
W01GSM appears on the Trunks page with the current status of Signal Quality, which is normally updated every
30/60 seconds.
2/2