Wildix W04FXO User manual

W04FXO 2020 Quick Installation Guide
W04FXO 2020 Quick Installation Guide Page 1 of 3
Sep 22, 2020 00:40
W04FXO 2020 Quick Installation Guide
Overview and LED indicators
04FXO Overview
LED indicators description
Installation and network connection
Network connection
Provisioning
Configuration
Factory reset
Overview and LED indicators
04FXO Overview
1 - DC 12V power supply (optional, WMP code: ) PS-12V2A
2 - FXO ports 1-4
3 - WAN/ PoE port
4 - LAN port
The Document describes how to connect and configure W04FXO Media Gateway.
Useful links:
Media Gateways Datasheet
W04FXO old generation - Quick Installation Guide
Created: September 2020
Permalink: https://confluence.wildix.com/x/swGmB

W04FXO 2020 Quick Installation Guide
W04FXO 2020 Quick Installation Guide Page 2 of 3
5 - FXO 1-4 LED indicators
6 - Power indicator: shows power supply status
7 - Running indicator: indicates network registration status
8 - Reset button
LED indicators description
Indicator Definition Status Description
PWR Power indicator On The device is powered on
Off There is no power supply or power supply is abnormal
RUN Running indicator Slow
flashing The device is running properly
Fast
flashing SIP registration is successful
Off The device is running improperly
FXO 1-4 FXO In-use
indicators On FXO port is currently occupied by a call
Off FXO port is idle or faulty
WAN/PoE/
LAN Network indicators Green flashing The device is properly connected to network
Off The device is not connected to network or the connection
is improper
Installation and network connection
Connect network cable to WAN/ PoE port
Connect analog line to the FXO port(s)
Network connection
W04FXO has two kinds of work mode: route and bridge:
when it is set to route mode, it works as a small router and NAT function has enabled. In this situation,
WAN port is normally connected to uplink router/ switch, LAN port used to connect local computer or other
network device (such as Ethernet switches, Hubs etc)
Note: W04FXO 2020 is a wall-mounted Media Gateway.

W04FXO 2020 Quick Installation Guide
W04FXO 2020 Quick Installation Guide Page 3 of 3
when it is set to bridge mode, WAN and LAN port are the same. It just works as Ethernet switch. When it
set to bridge mode, you only need to configure WAN port IP address and DNS. If you set it to route mode,
default LAN port IP is displayed and it can be change by users
Provisioning
Follow our to provision the gateway.Provisioning of Wildix devices - Admin Guide
For remote/ unreachable media gateways behind NAT/Firewall, follow our .online Guide to remote provisioning
Configuration
Follow to correctly set up the trunk parameters of the FXOISDN - FXO - GSM - SIP Trunk Settings Admin Guide
gateway.
Factory reset
Use the paper clip or the object of the similar shape to press the buttonReset
Keep the button pressed up to 15 seconds
When PWR and RUN LED indicators become steady green, the reset of the Gateway is complete