Wildix W04FXO User manual

W04FXO - Quick Installation Guide - English
W04FXO - Quick Installation Guide - English Page 1 of 4
Aug 14, 2020 18:55
W04FXO - Quick Installation Guide - English
Read the white paper: https://drive.google.com/open?id=10kpqi9yJM6gZ7E_YhkmHX6g0pSOTL0KB
Quick Overview
Connection to power supply (old models without PoE)
Connection to Ethernet
Connection to the line
Provisioning of the gateway
Edit the trunk parameters
Reset of the gateway
Quick Overview
Rear panel
Reset switch
Power supply
Input: AC100V~240V, 50/60Hz
Output: DC 12V, 1.5A
Network ports
2 Ethernet ports RJ-45, 10/100 base-T
1 WAN port
1 LAN port configured in Bridge
FXO ports
4 analog ports RJ-11
Front panel
1 Power LED indicating that the gateway is powered
1 Status LED indicating that the gateway functions
1 Proxy LED indicating that the gateway is registered on SIP proxy
The steps below help you to connect and configure the FXO gateway. Thanks to W04FXO gateway, you
can connect analog lines to your IP PBX, but not only; you can enhance your legacy PBX with Unified
Communications capabilities.
Updated: June 2015
Supported starting from WMS version 2.0.16043.9
Permalink: https://confluence.wildix.com/x/Vwg8AQ

W04FXO - Quick Installation Guide - English
W04FXO - Quick Installation Guide - English Page 2 of 4
1 LAN LED indicating that the gateway is connected to the network via this port
1 WAN LED indicating that the gateway is connected to the network via this port
4 LEDs Line1…Line4 indicating that the activated analog ports are connected:
blinking LED indicates that the line is activated but not connected
LED is ON indicates that the line is busy in the conversation
LED is OFF indicates that the line is connected and free
Connection to power supply (old models without PoE)
Connect the gateway using the power supply and the cable provided with the gateway, as it is shown on the
picture:
Connection to Ethernet
The gateway has one LAN port configured in Bridge mode and one WAN port set up as a DHCP Client. Connect
one of two ports to the same network as the PBX or an external DHCP server (for instance, its router) as shown
on the picture:
As soon as the DHCP server assigns an IP address to the gateway, you can pass to the next step of the
gateway configuration.

W04FXO - Quick Installation Guide - English
W04FXO - Quick Installation Guide - English Page 3 of 4
In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
In case an external DHCP server is used, check the list of the active leases to detect the IP address
assigned to the gateway
Connection to the line
W04FXO gateways have 4 ports on the rear part of the devices, marked as Line1, Line2, Line3, Line4. Connect
the needed ports to the analog lines.
Provisioning of the gateway
Follow our to provision the FXO gateway.online Guide
For remote/unreachable media gateways behind NAT/Firewall, follow our .online Guide to remote provisioning
Edit the trunk parameters
Follow our to correctly set up the trunk parameters of the FXO gateway.online Guide
Reset of the gateway
In case you need to reconfigure the gateway, you should perform a reset procedure, as shown on the picture.
The switch marked as “Reset/Default” is situated on the rear panel of the gateway.
use the paper clip or the object of the similar shape to press the button
keep the button pressed for 5 seconds
when the LED Status turns on, the reset of the gateway is complete

W04FXO - Quick Installation Guide - English
W04FXO - Quick Installation Guide - English Page 4 of 4