Woodard Uptown WI-300-T User manual

Uptown 28" Bistro Table
WI-300-T/121303
Assembly Instructions
Step 1: Remove protective wrapping first. Then lay all parts on floor and identify all parts packed in
carton against attached parts list.
Step 2: Lay Table Top Frame (A) upside down on floor, so bottom is facing up. Place a protective soft
material on floor before placing table top face down on floor.
Step 3: Then attach each of four legs (B) to the bottom ,using Bolt (D) and Washer (F) and Bolt
cover(G) as shown in Diagram 1. After that, attach center stretcher (C) to legs (B),using Bolt(E) and
Washer (F) and Bolt cover(G) as shown in Diagram 1.
Step 4: Make sure all bolts are aligned properly and tightened sufficiently. Then place bolt covers over
bolts and turn the table over onto it's legs carefully using a flat surface.
NOTE: IT IS USER'S RESPONSIBILITY TO MAKE SURE ALL PARTS ARE ASSEMBLED AND
TIGHTENED PROPERLY AND SECURELY.
WARNING!: TABLE IS NOT MEANT FOR SITTING. DO NOT SIT OR LEAN FULL BODY AGAINST
TABLE.
1 of 2

PARTS LIST
Ref Part Name Part Image Qty Ref Part Name Part Image Qty
A Table top 1 E Bolt (1/4“x12) 8
B Leg 4 F Washer (M6) 12
C Center Stretcher 1 G Bolt cover 12
D Bolt (1/4“x15) 4 H Hex wrench 1
WOODARD
Customer Service Hours
8:00am-5:00pm CST Monday to Friday
Phone: [phone] Fax: [phone]
PRINTED IN CHINA
2 of 2