Woodbridge B0735 Assembly instructions

WOODBRIDGE

20230725 REV.2

WOODBRIDGE

www.woodbridgebath.com 2

DIMENSIONS/TECHNICAL DATA

WOODBRIDGE DELUXE ONE PIECT TOILET

IMPORTANT INFORMATION

Measurements are ±

28 1/2"

"2/141

"8/351

"4/101

2 1/2" 14 1/4"

12"

5 1/2"

Standard

"8/151

"22

7 1/4"

18"

"2/11

WOODBRIDGE

www.woodbridgebath.com

12"

Standard

Wall

Floor

WATER SUPPLY LOCATION & TECHNICAL INFORMATION

12"

15"

Standard

12"

4 1/2"

10"

Supply

Threaded

Side View

Back View

Supply

Wall

Floor

Flush GPF amount is factory

is required.

Tank Top View (Inside)

Half

Flush

You may connect the water supply line using two diﬀerent

opons. In both opons distance from the ﬂoor to the

center of the supply line must be 5 1/2". In Supply Posion

1, the water supply is located behind the toilet and is

oﬀset by 4 1/2" from the installed toilet's center. In supply

Posion 2 the water supply line must oﬀset by 10" from

the center of the installed toilet.

Adjust the water level in the

toilet's tank if neccessary by

screw to increase or

decrease a level of water

in the toilet's tank.

Full

Flush

WOODBRIDGE DELUXE ONE PIECT TOILET

IMPORTANT INFORMATION

Measurements are ±

WOODBRIDGE

www.woodbridgebath.com 6

TOILET SEAT ADJUSTMENT

WOODBRIDGE DELUXE ONE PIECT TOILET

WOODBRIDGE

ADJUSTMENT & MAINTENANCE (DUAL FLUSH VALVE)

Gasket

Check the dual ﬂush

valve and make sure that

it does not have any

damaged or missing

parts

Install a body of the ﬂush

into the base and make

sure they can be totated

clockwise arbitrarily.

Install the base with the

rubber gasket in the

tank, turn the screw as

illustrated to make sure

there is no water leakage

and no looseness

Full ﬂush and half Flush range

will decline when the buon is

moved upward from the boom

Check the completeness

of the product before

adjustment

Take out the lock nut and

insert the push buon

into the tank cover

Adjust the push buon

and lock the nut to make

it well-ﬁxed in the tank

The distance between the

rod tail and valve push

buon must be 1-2mm

Rotate the valve

clockwise to adjust its

posion inside of the

toilet's tank

Install the sealing gasket

Put the reﬁll tube into the

white cap hole ﬁrmly

The reﬁll tube can't be lower

than the watersealing level

If the rod is too short, please

re-adjust it (outward

rotaon).

If the rod is too long please

cut-oﬀ the extra length and

re-adjust it.

1. BASE INSTALLATION

2. FLUSH VOLUME ADJUSTMENT

3. PUSH BUTTON ADJUSTMENT

4. REFILL TUBE ASSEMBLY TROUBLESHOOTING

Full Flush Half Flush

RIGHTWRONG

Water

Level

Important Note: Flush GPF amount is factory set. No addi onal adjustment is required.

This page is for reference only. All adjustments are already made by manufacturer.

WOODBRIDGE DELUXE ONE PIECT TOILET

www.woodbridgebath.com

WOODBRIDGE

ADJUSTMENT & MAINTENACE (FILL VALVE)

Instrucons:

When valve installed, the crical level mark

on ﬁll valve (idenﬁed by C.L. mark on

valve body) shoud be at least 1" above top

of the over ﬂow pipe.

Required:

• Water temperature: 36-112ºF

Important:

Under no circumstances seller shall not be liable for any and

all incidental damages sustained in connecon with this

product

Neither manufacture, nor distributor, nor retailer is

responsible for water damage or ﬂood caused due to use of

this product.

Under no circumstances seller shall not be liable for any and

all fees, cost of installaon/reinstallaon/removal,

subsequent damage or transportaon in case of the product

defect

95mm

58mm

mm981niM,mm982xaM

M( )mm442niM,mm443xa

09niM,mm032xaM mm

541niM,mm582xaM( )mm

Max 19.5mm - Min 8.5mm 45mm

Check the ﬁll valve and

make sure that it does

not have any damaged or

missing parts

1. Press buckle and unscrew.

2. Pull the valve upwards or press down to desired height.

3. Unscrew the valve body and fasten the buckle

Rotang screw, rise or lower the water level

to adjust water level to suitable posion

(water volume will gradually increase when

the adjuster is moved upward from the

boom.)

1. PREPARATION

2. WATER LEVEL ADJUSTMENT

Press and

unscrew

Soluon 1

Pull upwards

press down to

desired height

Unscrew

clockwise

and fasten

valves

Rotate screw to adjust

desired water level

Soluon 2

Install the valve into tank. Do

not use any wrench tools.

Fasten with hand only.

Connect water supply to the ﬁll

valve. Turn on water.

Turn oﬀ water supply valve

before height adjustment of the

toilet's ﬁll valve.

Put the reﬁll tube into the white

cap hole ﬁrmly.

3. FILL VALVE INSTALLATION

IMPORTANT: Do not use or drop any chlorine or any other chemicals. Use of chemical products will result in damage to the ﬁll

valve and ﬂush valve components and may cause ﬂood and property damage. Do not overghten bolts/nuts as it may and will

cause damage to the toilet parts and componets.

Important Note: Flush GPF amount is factory set. No addi onal adjustment is required. This page is for reference only.

All adjustments are already made by manufacturer.

C.L.

WOODBRIDGE DELUXE ONE PIECT TOILET

Remove the worn-out ﬁngs and clean your tank prior to the installaon of the new ones. There might be a lot of impuries in your

tank that may cause damage to the new parts if you do not clean them out. The tank must be absolutely clean prior to installaon.

www.woodbridgebath.com

WOODBRIDGE

CLEANING & TROUBLESHOOTING (FILL VALVE)

Shut oﬀ water supply line

before ﬁlter cleaning.

Water level is too high or

too low

Improper water level

adjustment

Adjust the water level

Fill valve fails to shut oﬀ

or fails to ﬁll the water

into the toilet's tank

Use so sponges or so-cloths to clean the surface. Always rinse thoroughly any cleaning soluons immediately aer cleaning. Do

not any chemical remain on the surface for extended periods of me.

Do not pour any mounts of chlorine or any other chemicals into the tank. Use of chemical products will result in damage to the ﬁll valve and

ﬂush valve components and may cause ﬂood and property damage and will void warranty.

Note: ﬁll and ﬂush valves are maintenance free. No maintenance is required.

1. Inlet valve switch is

turned on.

2. Inlet valve ﬂoat crashed

against ceramic wall

3. Filter screen is clogged

due to dirty water

4. Improper reﬁll hose

installaon

1. Turn on inlet valve switch

2. Adjust inlet valve posion

3. Clean the ﬁlter screen

4. Install reﬁll hose correctly (see

diagram on the right)

Carefully, take out the ﬁlter

from inlet by using pliers.

Use water to wash and clean

the ﬁlter and adapter from any

debris.

Re-install the ﬁlter and

re-connect the water supply

line.

FILL VALVE CLEANING

TROUBLESHOOTING

FILL/FLUSH VALVES MAINTENANCE & CARE

MAINTENANCE & CARE

Issue Cause Solu on Solu on #4

RIGHTWRONG

Water

Level

Retain these installa on instruc ons for future reference!

IMPORTANT!

DO NOT USE:Abrasive cleaners such as: acid, ammonia, bleach, and simmilar soluons. Use of such soluons may cause

corrosion, ﬁnish peeling, and/or dull the surface.

DO NOT USE:Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch the surface.

WOODBRIDGE DELUXE ONE PIECT TOILET

Thank you for using WoodBridge products!

Customer Service Phone: 562-229-0088. (Monday - Friday 9 AM - 5 PM Pacic

Time) Or Email:

www.woodbridgebath.com

Other manuals for B0735

Table of contents

Other Woodbridge Toilet manuals

Woodbridge

Woodbridge B0940 User manual

Woodbridge

Woodbridge BID 02 User manual

Woodbridge

Woodbridge T-0035 Assembly instructions

Woodbridge

Woodbridge V8300 Assembly instructions

Woodbridge

Woodbridge B0990S Assembly instructions

Woodbridge

Woodbridge B0950S Assembly instructions

Woodbridge

Woodbridge T0002W/B0720 Assembly instructions

Woodbridge

Woodbridge T-0022 Assembly instructions

Woodbridge

Woodbridge B0931S User manual

Woodbridge

Woodbridge LT610 Assembly instructions

Woodbridge

Woodbridge B0735 Assembly instructions

Woodbridge

Woodbridge T-0044 Assembly instructions

Woodbridge

Woodbridge B0970S User manual

Woodbridge

Woodbridge BW5100S Assembly instructions

Woodbridge

Woodbridge T0001 User manual

Woodbridge

Woodbridge T0033 Assembly instructions

Woodbridge

Woodbridge T-0032/B0750 Assembly instructions

Woodbridge

Woodbridge T-0047 Assembly instructions

Woodbridge

Woodbridge T-0031/B0500 Assembly instructions

Woodbridge

Woodbridge B0970S User manual

Woodbridge

Woodbridge B0930S User manual

Woodbridge

Woodbridge B0942 Assembly instructions

Woodbridge

Woodbridge B0980S Assembly instructions

Woodbridge

Woodbridge B0950S/V8300 Assembly instructions

Popular Toilet manuals by other brands

Xylem

Xylem Jabsco 37010 Series manual

agape

agape PEAR 2 Assembly instructions

SFA

SFA Sanicompact EMB5083 Installation and operating manual

Biolet

Biolet BTS 33 owner's manual

URIMAT

URIMAT ceramic 20 NRV 12220 Installation instruction

Toto

Toto CS818C Series installation manual

Kohler

Kohler K-3480 quick start guide

Toto

Toto SW3024 instruction manual

American Standard

American Standard Champion PRO 211BA Series INSTALLATION INSTRUCTIONS CARE AND MAINTENANCE

American Standard

American Standard Studio Right Height 2794 INSTALLATION INSTRUCTIONS CARE AND MAINTENANCE

Ideal-Standard

Ideal-Standard Connect Pure Installation

Icera

Icera St. Thomas Series Installation & Care Guide

MSW Motor Technics

MSW Motor Technics MSW-M-PT-13L-20L user manual

Dometic

Dometic CT 4110 operating manual

Anzzi

Anzzi ZEUS T1-AZ058 install guide

Delabie

Delabie 130200 manual

Swiss Madison

Swiss Madison SM-1T113 installation instructions

Franke

Franke 7612979002225 Installation and operating instructions