Worker 1389 User manual

1
IN 1389 SCOOTER WORKER CITY - EN
USER MANUAL

2
IMPORTANT: PLEASE READ THIS MANUAL THOROUGHLY BEFORE
ASSEMBLING, RIDING OR PERFORMING MAINTENANCE ON THIS SCOOTER.
WARNING
.For Ages 6 and Up
. Maximum Child’s weight: 100kgs.
. Check and tighten bolts and screws before every ride.
. Make sure all components are functioning properly before every ride.
.Maintain inflation of the tires to no more than the maximum inflation marked on the
side of the tire.
. Rider should wear proper protection while using this product.
Please wear a Helmet, knee and elbow pads, and shoes. This will greatly reduce
the chance of injury, but cannot protect form all injuries.
. If any component is damaged or not functioning properly, it should be replaced before
the product is used.
. Avoid sharp bumps, drainages grates and sudden surface changes.
. Avoid streets and surfaces with water, sand, gravel, dirt, leaves and other debris.
Wet weather impairs traction, braking and visibility.
.Avoid excessive speed associated with downhill rides when you are riding your
scooter.
.Brake will get hot with continuous use, do not touch after braking.
IMPORTANT
WARNING: An Adult must assist in the initial assembly of the scooter.
Be sure your scooter is fully assembled before riding.
Read and understand this owner’s manual before using the scooter.
Failure to do so can result in serious injury
PRECAUTIONS FOR SAFETY
THISSCOOTERISNOTRECOMMENCEDFORPERSONSUNDER6YEARSOFAGEOROVER
60KGS.
Please read and follow the safety precautions listed below, failure to do so could
result in injury or damage to your scooter.
PLEASE INSTRUCT YOUR CHILD ON THE PROPER OPERATION OF THIS SCOOTER.ALSO

3
INSTRUCTYOURCHILDTOFOLLOW THE SAFETYPRECAUTIONS LISTEDBELOW.
WARNING:
DONOTtakethis scooter on roads.
Wearahelmet.
Do notride nearmotorvehicles.
Practicebrakingin asafeenvironment.
Never ridenearsteps,slopeddriveways,hills, roadways, Alleys,swimming poolareas
orotherbodiesofwater.
Neverallowmorethanonerideronthescooter.
Never ride the scooter in wet weather. Wet surfaces mayIncrease stopping distance
whenbraking.
Nevertowwagons,othervehicles,childrenonskatesorskateboards.
DONOTrideatnight
Alwayswear shoeswhenridingthisscooter.
Givepedestrianstheright-of-way. Don’t ride too close to pedestrians.
Avoid hazards which may hinder your ability to control your Scooter. Potholes, ruts,
uneven payment, storm grating, Gravel, curbs, leaves, puddles and debris can all
have an Effecton yourridingand result inlossof control.
Donotrideoffroadoronroughpayment.
Keepbothhandsonthehandlebar.
Don’t wear anything that restricts your hearing.
CAUTION:Brakegentlytoavoidskiddingor sudden stops.
Skiddingmaycauseexcessivewear and damagetothescooterwheels.
ASSEMBLY INSTRUCTIONS
Remove ScooterFromboxandcheckforanymissingordamagedparts.
(Notethe tires comeinflatedwith air butmayloosesomeair duringshipping. Makesuretheare
inflatedto35PSI.)
TheassemblyoftheBikeScooterconsistsof2main.
Steps.1.WheelInstallation–2.HandleBarInstallation.
WHEELINSTALLATION
Installwheelswithaxlespushedfullyintoaxleslots.Makesuretoinstall

4
Tab washers (a) sothatthetabis insertedintotheroundholeintheframe.
Thiswashershouldbeontheoutsideoftheframe.Betweentheframeand
Axlenut.Makingsurewheelsarecentered,tightentheaxlenuts(b)
Firmlywithawrench.
NOTE:SeeFig.INextPage
NOTE:Frontandrearwheels areinstalledthesameway.
WHEEL INSTALLATION (fig 1)
Note:TheBackWheelmaycomepre-installed.
Duringwheel installationmakesurethetopedgeofthe
brakepadisevenwiththetopedgeoftherim ofthewheel.
BackWheel
Insertintoaxleslots.
Installthetabwasher
First(a).Theninstall
theaxlenut(b)
Tightenwithwrench
Frontwheel
Insertintoaxleslots.
Installthetabwasherfirst(a)
Theninstalltheaxlenut(b)
Tightenwithwrench
hANDLE BAR ASSEMBLY
HANDLEBAR,STEMANDGRIPS
1.Installthestemofthehandlebars(seefig2)intotheForkTube.
Positionparalleltothefrontwheel.Tightenthestem boltbyusingawrench.
Makesurethestem isinstalledbelowthe MaxHeightmark.
图片
轮
胎

5
Handle Bar
Insert(install)steminto Insertstem
ForkTubeatleastto intofork tube
theminimuminsertionLine
andTightenExpanderBolt(c)
withawrench
Assemble and Adjust Hand Brakes
Warning:The handbrakes onthis bikescooter werenot adjusted atthefactory
Before youridethis bikescooter youmustassembleandadjustthehand brakes.
Installbrakeleversontohandlebar.Thebrakeleverontherighthandsideconnects
to the front brake. and the brake lever on the left hand side connects the rear brake.
1.Insertthebarrelendofthebrakecableintotheholeinthebrakelever.
(SeeIllustration)
A) Squeeze the rear brakearms with yourhand (SeeIllustrationD) untilthebrake
rubbersareupagainstthe wheelrim.Thiswillenabletheinnerbrakecablewireto
be loose. and have enoughspaceforyoutoeasilyslipthe barrel end ofthebrake
cablewireintotheholeinthebrakelever.
2. Next,pull the brakecablewirethrough thekeyholeslot inthefrontofthebrake
lever(SeeIllustrationB)andthenremoveyourhand.Thebrakecablecapwill
automaticallyspringbackintotheslottedkeyholeonthefrontof thebrakelever
assemble.(SeeIllustrationC)
3. Next,proceedto adjustthehandbrakes.
Loosentheanchorboltnut.(seeIllustrationD)
Againsqueezethebrakerubbersagainstthewheelrim.
Pullthebrakecablewirethroughtheanchorbolthole.(SeeIllustrationD)

6
Untilthereisnoslackintheinnerbrakewire.
Tightentheanchorboltnut.
Squeezethebrakeleverhardandthenreleaseseveraltimes.rotatethe
wheel,besurethe wheeldoesnotwobble.Thereshouldbeabout1/16inch
6mm)clearance.betweenthewheelrimandeachbrakerubber.
Brakecable
Cableadjusterscrew r
Cableadjuster lock nut
Innerbrakecablewire
Anchorbolt&nut
Note:Ifadditionalbrakeadjustingisrequired,you canbringthebrakerubbers
closer tothewheelrim byturning the adjustingscrewcounter-clockwise.To
makethebrakerubbersfurtherfromtherim.turntheadjustingscrewclockwise.
Besurethecableislockedsecurelythroughtheanchorbolt.(SeeIllustrationD).
Resetcableadjustinglocknutwhenadjustingisfinal.Warning:If after brake
adjustmentsaremadeandthehandbrakestilldoesnotfunction.thenhavebrake
repairedoradjustingatabicyclesserviceshop.Donotrideifbrakedonotfunctionproperly.
TERMS AND CONDITIONS OF WARRANTY,
WARRANTYCLAIMS
General Conditions of Warranty and Definition of Terms
All Warranty Conditions stated hereunder determine Warranty Coverage and
Warranty Claim Procedure. Conditions of Warranty and Warranty Claims are
governed by Act No. 40/1964 Coll. Civil Code, Act No. 513/1991 Coll., Commercial

7
Code, and Act No. 634/1992 Coll., Consumer Protection Act, as amended, also in
cases that are not specified by these Warranty rules.
The seller is SEVEN SPORT s.r.o. with its registered office in Borivojova Street
35/878, Prague 13000, Company Registration Number: 26847264, registered in the
Trade Register at Regional Court in Prague, Section C, Insert No. 116888.
According to valid legal regulations it depends whether the Buyer is the End
Customer or not.
“The Buyer who is the End Customer” or simply the “End Customer” is the legal entity
that does not conclude and execute the Contract in order to run or promote his own
trade or business activities.
“The Buyer who is not the End Customer” is a Businessman that buys Goods or uses
services for the purpose of using the Goods or services for his own business
activities. The Buyer conforms to the General Purchase Agreement and business
conditions to the extent specified in the Commercial Code.
These Conditions of Warranty and Warranty Claims are an integral part of every
Purchase Agreement made between the Seller and the Buyer. All Warranty
Conditions are valid and binding, unless otherwise specified in the Purchase
Agreement, in the Amendment to this Contract or in another written agreement.
Warranty Conditions
Warranty Period
The Seller provides the Buyer a 24 months Warranty for Goods Quality, unless
otherwise specified in the Certificate of Warranty, Invoice, Bill of Delivery or other
documents related to the Goods. The legal warranty period provided to the
Consumer is not affected.
By the Warranty for Goods Quality, the Seller guarantees that the delivered Goods
shall be, for a certain period of time, suitable for regular or contracted use, and that
the Goods shall maintain its regular or contracted features.
The Warranty does not cover defects resulting from:
User’s fault, i.e. product damage caused by unqualified repair work, improper
assembly, insufficient insertion of seat post into frame, insufficient tightening of
pedals and cranks
Improper maintenance
Mechanical damages
Regular use (e.g. wearing out of rubber and plastic parts, joints etc.)
Unavoidable event, natural disaster
Adjustments made by unqualified person

8
Improper maintenance, improper placement, damages caused by low or high
temperature, water, inappropriate pressure, shocks, intentional changes in design or
construction etc.
Warranty Claim Procedure
The Buyer is obliged to check the Goods delivered by the Seller immediately after
taking the responsibility for the Goods and its damages, i.e. immediately after its
delivery. The Buyer must check the Goods so that he discovers all the defects that
can be discovered by such check.
When making a Warranty Claim the Buyer is obliged, on request of the Seller, to
prove the purchase and validity of the claim by the Invoice or Bill of Delivery that
includes the product’s serial number, or eventually by the documents without the
serial number. If the Buyer does not prove the validity of the Warranty Claim by these
documents, the Seller has the right to reject the Warranty Claim.
If the Buyer gives notice of a defect that is not covered by the Warranty (e.g. in the
case that the Warranty Conditions were not fulfilled or in the case of reporting the
defect by mistake etc.), the Seller is eligible to require a compensation for all the
costs arising from the repair. The cost shall be calculated according to the valid price
list of services and transport costs.
If the Seller finds out (by testing) that the product is not damaged, the Warranty Claim
is not accepted. The Seller reserves the right to claim a compensation for costs
arising from the false Warranty Claim.
In case the Buyer makes a claim about the Goods that is legally covered by the
Warranty provided by the Seller, the Seller shall fix the reported defects by means of
repair or by the exchange of the damaged part or product for a new one. Based on
the agreement of the Buyer, the Seller has the right to exchange the defected Goods
for a fully compatible Goods of the same or better technical characteristics. The
Seller is entitled to choose the form of the Warranty Claim Procedures described in
this paragraph.
The Seller shall settle the Warranty Claim within 30 days after the delivery of the
defective Goods, unless a longer period has been agreed upon. The day when the
repaired or exchanged Goods is handed over to the Buyer is considered to be the
day of the Warranty Claim settlement. When the Seller is not able to settle the
Warranty Claim within the agreed period due to the specific nature of the Goods
defect, he and the Buyer shall make an agreement about an alternative solution. In
case such agreement is not made, the Seller is obliged to provide the Buyer with a
financial compensation in the form of a refund.

9
SEVEN SPORT s.r.o.
Registered Office: Borivojova 35/878, 130 00 Praha 3, Czech
Republic
Headquarters: Delnicka 957, 749 01 Vitkov, Czech Republic
Warranty & Service Centre: Cermenska 486, 749 01 Vitkov, Czech
Republic
CRN: 26847264
VAT ID: CZ26847264
Phone: [phone]
E-mail: [email protected]z
[e-mail]
[email protected]z
Web: www.insportline.cz
SK
INSPORTLINE s.r.o.
Headquarters, Warranty & Service centre: Elektricna 6471, 911 01 Trencin,
Slovakia
CRN: 36311723
VAT ID: SK2020177082
Phone: [phone]
E-mail: objednavk[email protected]
[e-mail]
[email protected]
Web: www.insportline.sk
Date of Sale: Stamp and Signature of Seller: