Xtracycle PorterPack User manual

PorterpPack Manual 2021

01 installing the porterpack on
the porterrack
01 D
Place the PorterPack onto the PorterRack. Attach the bottom
hook and loop strap around the center support on the
PorterRack.
01 C
Open the hook and loop strap located on the bottom of the
PorterPack.
2
01 B
Before placing the PorterPack on the PorterRack, flip the
mesh pockets located on the back of the PorterPack onto
the pack’s lid. This will give you easy access to the rear
attached straps. Open these straps (blue arrow).
01 A
Prior to installation, the plastic panels that help the
PorterPack keep its shape must be installed. Slide these into
the pockets on the inside sides of the pack.
Please note:
The PorterRack is required for use with the PorterPack.

3
01 F
Flip the rear mesh pockets down and push them onto the
PorterPack to attach the backs of the pockets to the hook
and loop tape on the bag. Your installation is now complete.
01 E
Secure the hook and loop straps located on the back of the
PorterPack onto the corresponding horizontal bars on the
back of the PorterRack.

02 closing the roll-top
4
02 B
Clip the securing strap in place.
02 A
To roll the PorterPack top closed, press the top edges
together and roll them down towards the bag.

03 Converting the porterpack
into a basket
5
03 B
Clip the cinch strap into the buckle located inside the front
of the PorterPack. This prevents the strap from dangling and
potentially rubbing on the front wheel.
03 A
To use the PorterPack as an open basket, ensure the cinch
strap is not connected over the top. Press the roll-top into
the PorterPack, as if it is lining the bag.
Care & Maintenance
If the PorterPack becomes dirty, it can be gently
scrubbed with a washcloth and soap and water. Hand
wash only and air dry.