Xtracycle SlingSet User manual

SlingSet™Manual
REV1B
Our mission:
To empower people with
transformational tools that
move the body and spirit.
www.xtracycle.com
SKU: 3BG4000
SlingSet
www.xtracycle.com
What’s Included:
Because Sometimes You Want to
Also Carry the Kitchen Sink
Compatibility: The SlingSet is designed to work on all Xtracycle
models from 2000 to 2018 and beyond. This manual will
specifically walk you through the installation for the LEAP and
the EdgeRunner Swoop.
Warranty
Xtracycle SlingSets are guaranteed to be free from manufacturing defects for
one (1) year from the original date of purchase.
Defective products will be repaired or replaced at Xtracycle’s discretion. To determine if a warranty
claim is valid you may be required to return the product to Xtracycle for inspection. Xtracycle is not
responsible for removal, installation or shipping costs. This warranty applies only to the original buyer
and is not transferable.
This warranty does not cover damage from use of this product outside of its intended range or that
resulting from modification or neglect. It also does not cover wear and tear resulting from the normal
use of the product.
Double your warranty to two years!
Register your Xtracycle SlingSet within 14 days
of purchase to extend your warranty to two years.
http://www.xtracycle.com/register
Warning: Always use wheel protection like WheelSkirts or Xtracycle bags
when riding with passengers or cargo.
Warning: You must place the SlingSet over a WheelSkirt or CargoBay so that
cargo does not go into the rear wheel.
Note: Max Capacity: 50 lbs (22.7 kg)
Notices:
1 Pair of Slings
3 Male side-release buckles with hook-and-loop straps
3 Female side-release buckles with hook-and-loop straps

STEP 1: Prep
Place one Sling facedown. Xtracycle logo
should be facing the floor and away from you
with the Sling mounting side-release buckles
A & B closest to the bike.
Note: If using a Sling over a CargoBay
on an EdgeRunner or LEAP, buckle the Sling
to the frame upright, outside the vertical
webbing that connects the CargoBay to the
“chainstay” of the EdgeRunner or LEAP.
Attach side-release buckles A and B around
the vertical uprights on the frame, below the
RackLocks.
STEP 2: Clip to Frame STEP 4: Attach strapping buckles
STEP 3: Tension Sling
Pull tight on both ends until the bottom band
of the Sling is highly tensioned from front to
back. Let the Sling fall to the floor.
Note: The c-clip on the back of the nylon
webbing keeps the excess tail from getting
in your gears or spokes while riding. If the
strap ends are flapping around, make sure to
reattach the c-clip “slacker”.
Attach side-release buckles C,D, and E to the
top of the vertical rack using the hook-and-
loop straps provided. Then clip the buckles on
the sling (with long straps) to the mated buckle
that is looped to the rack.
Note: When installing a Sling on the LEAP
with a WheelSkirt, overlap the front of the
Sling with the WheelSkirt. Photo shown
installed with uncut (29+) V-Racks.
STEP 5: Install Other Sling
Repeat steps 1-4 on the opposite side of the
bike.
STEP 6: Buckle Over Top
Now you are ready to clip buckles over the top
of the deck for hauling bigger or bulky loads.