Xtracycle RFA Wheelskirt User manual

RFA wheelskirt
MANUAL 2021

01 B
Attach the side hook and loop straps. There are two toward the
back and one toward the front.
01 A
Attach the four top hook and loop straps of the WheelSkirt
to the pannier rail. Note that the 3rd loop from the front is
positioned in front of the middle vertical bar.
01 installing the rfa wheelskirt
on the rfa utility rearrack
01 C
Attach the three bottom hook and loop straps.
Repeat steps 01 A - 01 C for the WheelSkirt on the other side.
2

02 B
With this corner still folded down, fold the back half of the
WheelSkirt back along the dividing line. The corner will match
to a piece of hook and loop tape located on the backside of
the WheelSkirt, helping to hold it folded in place.
02 A
Prior to installation, the RFA WheelSkirt needs to be folded
down to fit the shorter Sport RearRack. To do this, lay the
WheelSkirt down flat, with the front side facing down. Fold
the back corner of the WheelSkirt - the one with a triangle of
hook and loop tape - down.
02 Installing the RFA WheelSkirt
on the rfa Sport RearRack
02 D
Attach the middle hook and loop strap on the backside of
the WheelSkirt onto the center vertical bar of the RearRack.
This strap is located on what is the rear-most end of the
WheelSkirts when they are unfolded. This helps hold the
folded portion of the WheelSkirt in place, preventing it from
becoming unfolded while in use.
02 C
You can now install the WheelSkirt on the RearRack. Holding
the WheelSkirt in position on the RearRack, install the top
hook and loop straps, the front hook and loop straps and the
straps on the bottom diagonal support.
3

4
02 E
Attach the one remaining hook and loop straps along the top
of the WheelSkirt and the two straps located at the end.
Repeat steps 02 A - 02 E for the other side.
Care & Maintenance
If the RFA WheelSkirts become dirty, they can be gently
scrubbed with a washcloth and soap and water. Hand
wash only and air dry.
02 F
Your RFA WheelSkirt installation is now complete.