Yukon Trail Outback 26 User manual

1) Carefully open the carton remove the foam packaging material,
then remove the bike and accessories.

2) Attach Front tire assembly to the front fork, adjust the front fork
and front wheel, install the nuts, then use the wrench to tight the nuts,
(Noted the direction of the tire tread).

3) Front fender assembly: install the front fender on front forks.
Position the fender to the Tire, tighten the screws as shown below.

4) Handle Bar assembly：insert the stem into the front fork as shown
below, adjust the height of the stem, adjust the direction to make
handle bars are aligned parallel with front tire.

5) Seat post assembly：release the “quick release assembly”, insert
seat post into the frame, adjust to desired height, then tighten the
"quick release assembly".

6) Pedal assembly：insert and tighten the right and left pedal onto the
cranks arm.(note the rotation and the left and right pedals which are
Marked with “L”and “R”).

7) Front V-brake: Insert brake cable sleeve into the slot as shown, note
the front wheel should rotate freely and the brake pads should not be
touching the rim. To adjust loosen nut and pull cable to desired
position.

8) Recheck assembly to ensure all nuts are properly tightened before
use.