Yukon Trail SolarWing 350 User manual

DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
Solar Go-kart Assembly Manual
1) Remove the top of the Solar Go Kart box by carefully removing the
staples on the four corners & carefully cutting straps and place cover
on ground as shown below.
Remove Safety Flag by carefully cutting the ties.
2) Carefully Remove Go Kart from box and place on flat surface

DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
3) Lift up the handle bar assembly while sliding up the control panel
until it is fully extended, tighten with Allen wrench provided. Make
sure to tighten the four nuts / bolts as shown below.
Bolt 1
Bolt 2 Bolt 3 Bolt 4

DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
4) Connect the lead wire of battery to connector of controller with firm
pressure.
5) When connecting the battery harness , be sure to snap connectors
Securely and zip the excess wires to frame.
6) Align the seat with the four Screw holes as shown below and
mount using 4 - M6×30 (1/4”×1-1/5”) bolts, use Allen wrench
provided. Bolts to be connect from the bottom of the Go Kart.
Bolt 1 Bolt 2
Bolt 3 Bolt 4

DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
7) Place Solar panel on the rear of the Kart (above Battery compartment)
Connect with the three bolts and washers as shown below.
8) Connect the Solar Panel cables securely

DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
9) Insert the Safety Flag by inserting into base next to left rear tire.
Caution: Do Not Operate Without Flag
10) Please charge the battery of minimum 8 hours before use.
Congratulations, Your SolarWing 350 Go Kart is ready for use.