Zempire NEO Series User manual

INSTRUCTIONS
Care Instructions -
1. Ensure guy ropes are out at all times during use
2. Never pack your tent away wet. If you must take your tent down when wet, ensure that it is dried
completely as soon as possible to prevent mildew forming
3. If mildew does form on your tent, wash o with warm water and a soft brush to prevent further growth,
do not use soap or detergents
4. Do not use an open ame inside your tent. The fabric has been treated with a re retardant but is in no
way re proof
5. Clean all pegs and poles before storing
6. This tent is not designed to withstand storm conditions. During strong winds, it is recommended that the
tent be taken down
7. Do not leave your tent pitched unnecessarily for extended periods of time, UV light damages the y and
will shorten the life of your tent
Condensation -
It is important that lower vents are opened at all times to reduce the risk of condensation. During humid or damp
conditions, it is recommended that inner door covers are opened to expose the mesh layer to allow additional
airow throughout your tent.
Do not use foam swabs or non bonded mats directly on the tent oor. This will cause condensation between the
mat and oor and if not dried out can lead to mildew foaming.
2 Year Tent Guarantee -
Please take time to read about the protections we oer you
All our tents come with a guarantee designed to protect you as our valued customer. Flow Imports Ltd, the
makers of Zempire Camping Equipment tents, will repair or replace this tent, at their discretion should it fail due
to faulty materials or manufacture for a period of 2 years from the date of sale.
The Guarantee is subject to the following conditions:
1. The Guarantee only applies to an original purchaser who purchased this tent from an approved retail
outlet
2. The Guarantee does not apply if the tent has been used for anything other than reasonable personal
camping use. Commercial use (e.g. rental) or continuous use as a residence are expressly excluded
3. Damage due to normal wear and tear, accident, acts of God, negligence (other than by Flow Imports Ltd),
failure by the purchaser to ensure instructions for setting up and care are observed, deterioration due to
abnormal exposure to ultraviolet light, insect or mildew attack, or any other cause reasonably beyond the
control of Flow Imports Ltd are not covered
4. If redress is sought under the terms of this Guarantee, then the tent must be returned by the purchaser to
the outlet from where it was purchased within the Guarantee period, in a clean, dry state and with proof
of purchase
5. All transport costs and any other indirect costs are excluded from the Guarantee.
6. Flow Imports Ltd reserves the right to make a reasonable charge for repairs which it determines are not
within the scope of the Guarantee
7. The Guarantee does not limit, modify or exclude any rights under any law if doing so would contravene
that law or make any part of this Guarantee invalid. However, Flow Imports Ltd:
a) excludes (to the extent permitted by applicable law) all conditions and warranties that might otherwise
be implied; and
b) limits its liability for breach of any such condition or Guarantee that it cannot exclude together with its
liability under the Guarantee, to repairing or replacing the Goods or paying the cost of having the Goods
repaired or replaced (at Flow Imports’ option).
This tent has been made with meticulous care and attention to detail. Providing it’s properly looked after and
correctly stored, it will help you enjoy all that nature has to oer for years to come.
Get out more - you owe it to yourself.
12+
EQUIPMENT
CAMPING
EQUIPMENT
CAMPING

1. Clear your site making sure there are
no sharp objects where you are going to
pitch you tent. Try to get a site that is as
at as possible. Spread out the inner tent
(white). The round door is located at the
front, the U door is located at the rear 2. Assemble the 8 pole sec-
tions. Ensure that the poles do
not snap together. Ensure the
pole does not snap together. It
is important that the poles are
fully inserted into the ferrules.
If the ferrules do not connect
together correctly they can
cause damage when tensioned.
3. Thread the RED poles through the
pole sleeves that run diagonally across
the centre of the tent. Insert the ends
of the poles into the pins located below
each pole sleeve. Attach the c-clips
around the poles
4. Thread the GREEN poles through
the GREEN trimmed pole sleeves on
either side of the dome you have just
created. Thread the YELLOW poles
through the YELLOW trimmed pole
sleeves at the outside of the bed-
room. Insert the pole ends into the
pins at the base and clip the c-clips to
the frame.
5. Thread the remaining BLUE poles
through the BLUE trimmed pole sleeves
that run across the front and rear doors
and above the rear bedroom. Insert the
ends of the poles into the pins and clip
the c-clips between the pole sleeve and
the pin onto the pole.
6. Firstly peg out the corners of each
room ( ), then peg out the remaining
peg loops ( ). The peg points at the
base of each pole should be pegged
through the webbing loop rather than
the ring. Try to get the oor sitting as
at as possible at each stage.
7. Pull the y over the inner tent. The
Zempire logo should be at the front
of the tent. Connect the Velcro loops
inside the y around the cut out on
the corresponding pole sleeve or
directly around the pole.
8. Attach the elastic loops over the
existing inner pegs. Where there is
not existing peg, peg the y directly
into the ground ensuring there is
signicant space between the inner
and y.
9. It is recommended that guy ropes
are pegged out at all times and win-
dows are opened whenever possible
to allow adequate ventilation. Try to
have the guy ropes at a 45Oangle to
the ground.
INSTRUCTIONS
3x
EQUIPMENT
CAMPING
12+