Zivan NG3 CANBUS User manual

ZIVAN ADJUSTMENTS
To Adjust Zivan NG3 Output Voltage
Please observe safety precautions
Steps:-
Disconnect the charger from AC supply & batteries.
Open cover by removing 4 screws
ocate Blue multiturn POT marked "V" on the control PCB (mounted vertically to the main power PCB).
ocate the "Selector Detail Switch"
Change the Selector Switch to position "7" . ( "F" on old models)
Connect an accurate DC voltmeter to charger output.
Apply AC power to the charger ( Do not connect batteries)
Charger should "beep" / fans turn ON / ED on control PCB indicate Green (With in 1-2 Secs)
When Green ED ON measure Output volts from charger
Adjust B UE POT "V" to get 165.6 V from charger.
Disconnect AC to the charger.
Carefully put the cover back while paying attention not to change the selector switch position and alignment
of ED against cover window.
Before putting the screws confirm output volts and ED alignment by applying AC to the charger.
(Selector Switch can be accessed from cover window by removing the black sticker)
Put the screws back.
Done !

Zivan NG3 Current Li it Alternation.
Please observe safety precautions
Steps:-
Need DC Clamp meter , DC volt meter & load / flat battery to draw max current from the charger
Disconnect the charger from AC supply & batteries.
Open Charger Cover by removing 4 screws. Be careful not to snap the "Selector Detail" switch when
removing the cover.
ocate the Blue POT marked "I " - Next to IC "U5" on the vertical control PCB.
Connect AC supply / / oad bank to the charger and turn ON the charger.
Ensure the charger is in C/ by monitoring the volts / amps from the meter.
Slowly turn the POT "I" while monitoring the output current via the DC clamp meter.
Depending on the direction of turn Current will either increase / or decrease.
Set the Current imit to 15A ps .
Verify this setting by putting enough load to force the charger into current limit. (If you are using a flat battery
as the load, the current may have actually dropped due to recharging of the battery)