ZKTeco PB4060 User manual

Contents I
Installation Guide
PB4060
Version: 1.0
Date: July 2018

Contents
Chapter 1 Cable Embedding................................................................................................................................................1
Chapter 2 Cabinet Installation ..........................................................................................................................................2
Chapter 3 Boom Installation.................................................................................................................................................3
Chapter 4 Cabinet Inside .......................................................................................................................................................4
Chapter 5 Troubleshooting ..................................................................................................................................................6

Chapter 1 Cable Embedding 1
Chapter 1 Cable Embedding
Prepare φ25 protective sleeve and cable in advance.
Route cables to be connected through protective sleeves.
Use a tool to open a cable tray on the ground, see Figure 1-1.
Figure 1-1 Cable embedding
The power wire is wrapped
and protected using the wire
sleeve when laid out under
the ground (the strong
current should be separated
from the weak current)
Control
room
Screw pad
Ground
Ground
Cabinet
Expansion bolt
4-M12
Base concrete

2 PB4060 Installation Guide
Chapter 2 Cabinet Installation
Use screw pad to mark the installation position of the cabinet.
Drive four expansion bolts into the bolt holes, as shown in Figure 2-1.
Install screw pads and use a wrench to tighten nuts, as shown in Figure 2-2.
Figure 2-1
Figure 2-2
Screw pad
Ground Ground
Base
concrete
Chassis
Expansion bolt
Cabinet

Chapter 3 Boom Installation 3
Chapter 3 Boom Installation
Pull the vice boom out from the main boom, then fastened by 2 screws, as shown in
Figure3-1.
Installing the boom to the chassis, as shown in Figure 3-2.
Figure 3-1 Connect the main boom with vice together by 2 screws
Figure 3-2 Installing the Boom to the cabinet

4 PB4060 Installation Guide
Chapter 4 Cabinet Inside
Interface of the main control board
Figure 4-1
Copy/delete key: (Copy) press the key, and then press any other key of remote controller until the
Copy/delete indicator light blinking.
(Delete) press the key until the Copy/delete indicator light blinking, then press the
Stop of testing key.
AC power input: Connection with 110/220V power according to type of your purchasing.

Chapter 4 Cabinet Inside 5
Mechanism core
Figure 4-2
Sensor: The sensor on the bottom of motor. It is using for that if the boom falling down press any other
obstacles, the boom will lifted up automatically.
Motor: AC power motor
Hall sensor: Connect to Limited switch port of control board, which limited the close/open position.
Shock absorber: A gel is used to absorb the pressure of close/open boom
Spring: Using it to keep balance with boom. For example, the boom changed short opening plastic nuts
to make spring loosen a little. Otherwise the boom may can’t close totally.

6 PB4060 Installation Guide
Chapter 5 Troubleshooting
NO. Failure description Analysis and solution
1Controller board’s indicator light show
normally, but motor does not work.
A. Check whether the motor capacitor did
connect correctly.
B. Check whether the sensor did connect
correctly.
2Boom has shock when the finally moment
of boom close/open.
A. Check whether the shock absorber gel was
damaged, if yes please replace a new one
B. Check whether the spring was fatigue
deformation, if yes please adjust or replace it.
3Boom barrier can't open/close totally.
A. After changed shorter boom, should have
adjusted spring to keep balance,
B. The plug of sensor did not connect correctly.
4The distance of remote controller
decrease.
The battery of remote controller no power,
change a new battery.
Attention: please make sure the power input match with device.