A-Tach Mounts ST-1 User manual

A-Tach # 50388
Designed for: Lexus GX 2010 - 2021
ST-1 A-Tach
Mounts
NOTICE: A-Tach Mounts will not be responsible for
any dama e to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causin dama e to your vehicle or
the product.
Read all instructions and view the photos before
attachin this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash BE ORE
attachin the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too bi or small for the intended location. The vehicle mount must be
installed BE ORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not desi ned to be attached and taken off the vehicle repeatedly or on a re ular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
top of the mount will attach into the seam and
under the top display frame illustrated with the
arrow in the photo.
(2) Insert the thin end of the seam tool into the
top seam to open the seam a little.
(3) Remove the coverin from the tape. Hook the
lower ed e of the mount under the top ed e of the
display frame. See photo.
(4) Press forward on the top of the mount and, at
the same time …
See additional instructions on the back side.

(5) Press down on the front ed e of the mount until
the front ed e oes all the way into the front / top
seam.
(6) The mount attached. The tape will not leave
any residue if the mount is removed in the future.
Warranty and Returns
A-Tach Mounts Limited Warranty
A-Tach warrants the product to be free of all defects in materials and workmanship for a period of six
(6) months from the date of purchase. This warranty extends to the ori inal buyer. Dama ed products
caused by anythin outside of shippin dama e are not covered by this warranty.
Within the period of this warranty, A-Tach has the option to repair or replace the item or refund the
purchase price. Any replacement parts will be done on an exchan e basis. All repairs and service must
be done by A-Tach. Product must be delivered to A-Tach durin the warranty time alon with proof of
purchase price and date. The shippin and packa in costs will be the buyer’s responsibility. Labor
costs and parts to repair will be A-Tach Mounts responsibility.
A-Tach Mounts will not be responsible for any dama e to the vehicle or product due to the installation
and/or use of the product. A-Tach is not responsible for dama es caused by extreme heat conditions.
Any above exclusion may not apply in states that do not allow the exclusion or limitation. This warranty
ives you specific le al ri hts. You also may have other ri hts which vary from state to state.
Returns
Before any product may be returned, A-Tach must ive prior approval. An RMA# (Return Merchandise
Authorization Number) needs to be iven to the buyer to return a product. All returns must be within
(30) days of the invoice date and include proof of purchase. Any returned product must be undama ed
and in like new condition. Returned product must be scratch free with no additional holes or screw
marks on the product.
A-Tach reserves the ri ht to withhold any refund if the product is believed to be dama ed. A return
must include a copy of the ori inal order or invoice. All parts and components that were shipped with
the ori inal product must be included with the returned product.
Contact Information:
A-Tach Mounts
Clarkston, WA 99403
[e-mail]