A-Tach Mounts 50322 User manual

A-Tach # 50322
Designed for: Volkswagen Taos 2022 - 20__
ST-1 A-Tach
Mounts
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle or product due to the
installation and or use of the product. The product has
been tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible to determine if you have the
skill to attach the product without causing damage
to your vehicle or the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash BE ORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BE ORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
upper edge of the mount will attach into the seam
between the frame around the display and the dash
panel covering the display illustrated with the
arrows in the photo.
(2) The lower edge of the mount will attach into
the seam between the frame around the vents and
the separating dash panel above the vents
illustrated with the arrows in the photo.
(3) Use the seam tool if needed to open the lower
seam a little.
(4) Remove the covering from the tape. Then
press the thin lower edge of the mount into the
lower seam. The lower side of the mount is longer.
See additional instructions on the back side.

(5) Remove the seam tool and insert it into the
seam illustrated in photo 1.
(6) Using two hands lift the upper edge of the
mount up and forward into the upper seam. The
tape will not leave any residue if the mount is
removed in the future.
Warranty and Returns
A-Tach Mounts Limited Warranty
A-Tach warrants the product to be free of all defects in materials and workmanship for a period of six (6) months
from the date of purchase. This warranty extends to the original buyer. Damaged products caused by anything
outside of shipping damage are not covered by this warranty.
Within the period of this warranty, A-Tach has the option to repair or replace the item or refund the purchase price.
Any replacement parts will be done on an exchange basis. All repairs and service must be done by A-Tach. Product
must be delivered to A-Tach during the warranty time along with proof of purchase price and date. The shipping
and packaging costs will be the buyer’s responsibility. Labor costs and parts to repair will be A-Tach Mounts
responsibility.
A-Tach Mounts will not be responsible for any damage to the vehicle or product due to the installation and or use
of the product. A-Tach is not responsible for damages caused by extreme heat conditions. Any above exclusion
may not apply in states that do not allow the exclusion or limitation. This warranty gives you specific legal rights.
You also may have other rights which vary from state to state.
Returns
Before any product may be returned, A-Tach must give prior approval. An RMA# (Return Merchandise
Authorization Number) needs to be given to the buyer to return a product. All returns must be within (30) days of
the invoice date and include proof of purchase. Any returned product must be undamaged and in like new
condition. Returned product must be scratch free with no additional holes or screw marks on the product.
A-Tach reserves the right to withhold any refund if the product is believed to be damaged. A return must include a
copy of the original order or invoice. All parts and components that were shipped with the original product must be
included with the returned product.
Contact Information:
A-Tach Mounts
Clarkston, WA 99403
[e-mail]