A-Tach Mounts 50366 User manual

A-Tach # 50366
Designed for: Jaguar F Pace 2016 - 2020
ST-1 A-Tach
Mounts
NOTICE: A-Tach Mounts will not be responsible for
any da age to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to deter ine if you have the skill to attach the
product without causing da age to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle ount over the place where the ount attaches to the dash BE ORE
attaching the device holder to the vehicle ount to ensure a proper fit with the location. Most often the
ount will appear to be a little too big or s all for the intended location. The vehicle ount ust be
installed BE ORE a device holder is screwed onto the vehicle ount.
Once screwed together the products are considered used and non-refundable.
The vehicle ount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should re ain attached until you would like to per anently re ove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the ount will attach. The
lower edge of the ount will attach into the sea
illustrated with the arrow in the photo.
(2) The upper edge of the ount will attach into
the sea illustrated with the arrow in the photo.
(3) Re ove the covering fro the tape. Use the
sea tool if needed to open the lower sea a little.
(4) Press the thin lower edge of the ount into the
lower sea .

See additional instructions on the back side.
(5) Re ove the sea tool and insert it into the top
sea . You ay need to press forward on the sea
tool to open the sea enough to get the top edge
of the ount into the sea .
(6) Press forward on the top of the ount until the
top edge of the ount hooks into the top sea .
The tape will not leave any residue if the ount is
re oved in the future.
Warranty and Returns
A-Tach Mounts Limited Warranty
A-Tach warrants the product to be free of all defects in aterials and work anship for a period of six
(6) onths fro the date of purchase. This warranty extends to the original buyer. Da aged products
caused by anything outside of shipping da age are not covered by this warranty.
Within the period of this warranty, A-Tach has the option to repair or replace the ite or refund the
purchase price. Any replace ent parts will be done on an exchange basis. All repairs and service ust
be done by A-Tach. Product ust be delivered to A-Tach during the warranty ti e along with proof of
purchase price and date. The shipping and packaging costs will be the buyer’s responsibility. Labor
costs and parts to repair will be A-Tach Mounts responsibility.
A-Tach Mounts will not be responsible for any da age to the vehicle or product due to the installation
and/or use of the product. A-Tach is not responsible for da ages caused by extre e heat conditions.
Any above exclusion ay not apply in states that do not allow the exclusion or li itation. This warranty
gives you specific legal rights. You also ay have other rights which vary fro state to state.
Returns
Before any product ay be returned, A-Tach ust give prior approval. An RMA# (Return Merchandise
Authorization Nu ber) needs to be given to the buyer to return a product. All returns ust be within
(30) days of the invoice date and include proof of purchase. Any returned product ust be unda aged
and in like new condition. Returned product ust be scratch free with no additional holes or screw
arks on the product.
A-Tach reserves the right to withhold any refund if the product is believed to be da aged. A return
ust include a copy of the original order or invoice. All parts and co ponents that were shipped with
the original product ust be included with the returned product.
Contact Information:
A-Tach Mounts
Clarkston, WA 99403
cs@atach ounts.co