A-Tach Mounts ST-2 User manual

A-Tach # 50387
Designed for: Volvo XC40 2018 - 20__
ST-2 A-Tach
Mounts
NOTICE: A-Tach Mounts will not be responsible for
an damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securel to the listed vehicles.
Instructions are provided for our convenience.
You are responsible for the use of the product and
to determine if ou have the skill to attach the
product without causing damage to our vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash EFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed EFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedl or on a regular basis.
Once it is attached, it should remain attached until ou would like to permanentl remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach into the two seams illustrated
with the arrows in the photo above.
(2) Insert the thin edge of the seam tool into the
top seam to open the seam a little. The mount
should be installed in the center of the displa
area.
(3) Remove the covering from the tape. Insert the
thin top edge of the mount into the seam next to
the seam tool.
(4) Insert the thin edge of the seam tool into the
top seam to open the seam a little. This is a ver
tight seam but it WILL OPEN. It will help to …
See additional instructions on the back side.

(5) Start b inserting the seam tool into the seam
on the side (See arrow above.) and then using both
seem tools graduall move the seam tools closer to
the area.
(6) Press the lower edge of the mount in and up
until the thin lower edge goes into the seam. The
tape will not leave an residue if the mount is
removed in the future.
Warranty and Returns
A-Tach Mounts Limited Warranty
A-Tach warrants the product to be free of all defects in materials and workmanship for a period of six
(6) months from the date of purchase. This warrant extends to the original bu er. Damaged products
caused b an thing outside of shipping damage are not covered b this warrant .
Within the period of this warrant , A-Tach has the option to repair or replace the item or refund the
purchase price. An replacement parts will be done on an exchange basis. All repairs and service must
be done b A-Tach. Product must be delivered to A-Tach during the warrant time along with proof of
purchase price and date. The shipping and packaging costs will be the bu er’s responsibilit . Labor
costs and parts to repair will be A-Tach Mounts responsibilit .
A-Tach Mounts will not be responsible for an damage to the vehicle or product due to the installation
and/or use of the product. A-Tach is not responsible for damages caused b extreme heat conditions.
An above exclusion ma not appl in states that do not allow the exclusion or limitation. This warrant
gives ou specific legal rights. You also ma have other rights which var from state to state.
Returns
Before an product ma be returned, A-Tach must give prior approval. An RMA# (Return Merchandise
Authorization Number) needs to be given to the bu er to return a product. All returns must be within
(30) da s of the invoice date and include proof of purchase. An returned product must be undamaged
and in like new condition. Returned product must be scratch free with no additional holes or screw
marks on the product.
A-Tach reserves the right to withhold an refund if the product is believed to be damaged. A return
must include a cop of the original order or invoice. All parts and components that were shipped with
the original product must be included with the returned product.
Contact Information:
A-Tach Mounts
Clarkston, WA 99403
[e-mail]