ADC Adtemp II 413 Maintenance manual

AdtempTM II 413
Digital Fever Thermometer
USE, CARE &
MA NTENANCE

2
Intended Use:
A digital thermometer is a device used to measure the body temperature of a patient by
means of a transducer coupled with an electric signal amplification, conditioning, and
display unit.
Safety Informat on:
• WARNING: High, prolonged fever requires medical attention especially for young chil-
dren. Please contact your physician.
• WARNING: Do not allow children to take their temperatures unattended.
• WARNING: Read the enclosed instructions carefully to ensure accurate temperature
readings. Temperature readings are affected by many factors including exercise, drinking
hot or cold beverages prior to taking a reading as well as technique.
• WARNING: Do not allow children to walk or run during temperature taking. The rigid
probe could present a hazard. Oral, underarm, and rectal temperatures vary by approxi-
mately 1°F (0.5°C).
• WARNING: Keep battery out of children’s reach. Swallowing battery could be harm-
ful. Battery should not be recharged or placed into extreme heat as it may explode.
• WARNING: This product may contain a chemical known to the state of California to
cause cancer, birth defects, or other reproductive harm.
• CAUTION: Do not take an axillary temperature through patient’s clothing. Direct
probe cover to skin contact is required.
• CAUTION: Biting the probe tip while taking a temperature may result in damage to
the probe.
• CAUTION:
Do not autoclave. Please note the cleaning procedures described in
this manual.
• CAUTION: Do not store the unit under direct sunlight, at a high temperature, or in
high humidity or dust. Performance may be degraded.
• CAUTION: Do not use this device close to strong electromagnetic fields such as mobile
telephones or radio installations. Keep a distance from such devices when using this
unit.
• CAUTION: IP22: Protected against solid foreign objects of 12.5 mm diameter and
greater. Protected against vertically falling water drops when the device is tilted up to 15°.
• CAUTION: Do not use the device if you it is damaged or if anything appears unusual.

3
How to take temperature:
1. Place a probe cover carefully over the tip (Fig-
ure 1). Select oral, underarm or rectal as your
measurement site based on the individual requir-
ing a temperature measurement.
2. Push the Multi-Function button located beside the display window. The ther-
mometer will beep and the display will read: “188.8 ° ”. This is a function check
indicating the unit is working properly. The last measured temperature will be dis-
played for approximately 2-seconds. Next the thermometer will read ---°F.(or ---°C)
3. The °F or °C symbol will flash when the unit is ready to measure temperature.
Please note that the “ ” indicates a low battery. See instructions for replacing battery
before measuring temperature. Do not expect an accurate temperature reading if this
low battery indicator is present. An “ERR” message in the window indicates your
unit is not functioning properly.
4. Depending on the measurement site, the unit will complete measurement in approxi-
mately 30-40 (oral), 25-35 (rectal), or 90 (axillary) seconds. The display will flash
and the unit will beep signaling completion.
5. Read and record the temperature and time for reference. The reading will automati-
cally be stored in the memory.
6. Push the Multi-Function button to turn the unit off. This will prolong the battery
life. If you do not turn the unit off, it will shut off automatically in approximately 8’40”±1’ min-
utes.
Oral use: (for children 4 years and older)
1. Do not drink hot or cold fluids, exercise or perform other activities that will raise
or lower temperature readings when compared to your normal, average temperature.
The mouth should remain closed up to 5 minutes before attempting a reading.
2. Place the probe tip well under the tongue as indicated
(Figure 2).
3. Instruct children not to bite down on the probe.
4. The peak temperature should be reached in as little as 30*
seconds. Opening the mouth or improper placement of the
probe tip could result in a longer time for a reading.
(*30 second response time achieved in water bath test)
Figure 1
Figure 2
F
M

4
Rectal use:
1. Commonly used for babies, young children or when it is difficult to take an oral
or underarm temperature.
2. After placing the probe cover on the thermometer, lubricate with a water-soluble
jelly or petroleum jelly.
3. Gently insert the probe tip no more than 1/2 inch or 1.3 cm into the rectum. Do
not force the tip into the rectum if resistance is encountered.
4. Dispose of the used probe cover and wash the thermometer as recommended.
5. The peak temperature should be reached in approximately 25-35 seconds.
Underarm (Ax llary) use:
1. Wipe underarm with a dry towel.
2. Place probe tip in armpit and bring arm down against the body.
3. The probe should be pointing upward in the same direction as your body if possible.
4. The time required for an accurate underarm temperature may be 90 seconds or
longer depending on placement of the probe and closure of the arm against the body.
Operat on of the °F - °C feature (How to change the measuring scale)
From the “OFF” position, hold down the “MU TI-FUNCTION” button for 5-sec. The
thermometer will automatically change from °F - °C or °C - °F. Release the button.
You may toggle between °C and °F. After 3-sec. in one scale the °C or °F will flash,
indicating ready to measure.
Chang ng the battery:
When the “ ” appears in the lower right of the display,
the battery is exhausted and needs replacing. Make sure a
battery of the same type is on hand and proceed as fol-
lows: Remove battery compartment lid. Use a small
Phillips screwdriver to remove battery. Insert new equiva-
lent battery type (1.55v, R41 or SR41). Ensure battery is
correctly positioned with the “+” facing up or towards the
display of the unit. Carefully replace the battery compartment lid. Properly dispose
of the batteries, keeping them from small children and heat.
BATTERY
BATTERY

5
Standards:
Complies with EN 12470-3, ASTM E 1112-00, IEC 60601-1, IEC 60601-1- 2
Electromagnetic compatibility: device fulfills the stipulations of standard
IEC 60601-1-2
The manufacturer recommends a calibration check every 2 years.
How to care for th s product:
• Use of probe covers is recommended to help avoid spreading germs, and to keep
the thermometer clean. The thermometer should be cleaned after use even when
probe covers are used.
• Clean the thermometer tip and probe only using isopropyl alcohol or soap and
water.
• Store the unit in the protective case while not in use.
• Do not store or keep in direct sunlight, or in high temperatures.
• Keep battery away from children.
• Do not open the thermometer except to replace the battery
• Do not drop the thermometer, as this may ruin the unit.
• The manufacturer recommends verifying the accuracy by an authorized laboratory
Parts and Assembly
Probe T p D splay W ndow Mult -Funct on Button

6
Size:
Weight:
Display:
Battery:
Battery Life:
Measurement Time:
Measurement Range:
Accuracy:
Measurement Mode:
Audible Alarm:
Auto Turn Off:
Memory Feature:
Operation Environment:
Storage Environment:
Expected Service Life:
Standard:
*30 second response time achieved in water bath test.
5”L x 3/4”W x 3/8”H (12.7cm L x 1.905cm W x .9525cm H)
0.388 oz (11 grams
LCD, Liquid Crystal Display)
1.55v (LR41) Alkaline
Estimated 4,500 measurements
Oral 30* Seconds / Rectal 25-35 Seconds /
Axillary 90 Seconds
90.0°F to 109.9°F / 32.0°C to 42.9°C
+/- 0.2°F/0.1°C between 96.0°F to 107.0°F / 34.0°C to 42.0°C
at a room temperature of 64.4°F to 82.4°F / 18°C to 28°C
+/- 0.4°F/0.2°C between 90.0°F to 96.0°F/ 32.0°C to 34°C
and 107.0°F to 109.9°F/ 42.0°C to 42.9°C.
Real measurement with peak-hold method
1 beep at start-up. Continuous beep at measurement
completion
n approximately 8 ±1 minutes
Stores last temperature taken
10 °C to 40 °C /50 °F to 104 °F, humidity of 15% to 95%
(noncondensing)
-13°F to 140°F (–25°C to 60°C), humidity of 15 % to 95 %
(noncondensing)
5 Years
EC60601-1-11
Spec f cat ons

7
WARRANTY: This Thermometer is guaranteed for a period of 24 months from date of
purchase. This warranty does not cover batteries, or damage resulting from improper
handling or use. Specific legal rights stipulated in your state may guide this warranty. If
you have a legitimate claim under this warranty, send item(s) postage paid to Service
Center, Attn: Repair Dept., 55 Commerce Dr., Hauppauge, NY 11788. Please include
your name and address, phone no., proof of purchase, and a brief note explaining the
problem., your return address and $2.00 to cover shipping and handling.
Visit www.adctoday.com to view this instruction booklet in other languages.
B p/n 93-413-00 rev 5
Read the instruction manual carefully be-
fore using this device, especially the
safety instructions, and keep the instruc-
tion manual for future use. Type BF applied part
Batteries and electronic devices must be
disposed of in accordance with the locally
applicable regulations, not with domestic
waste.
0044
Distributed by: ADC®
55 Commerce Drive,
Hauppauge, NY 11788
nspected in the USA
Made in China
tel: [phone]
toll free: 1-800-232-2670
fax: [phone]
www.adctoday.com
email: [e-mail]
Onbo Electronic (Shenzhen) Co., Ltd.
No. 497, Ta Laneg Nan Road, Ta Laneg Street
Baoan District, Shenzhen, China
Microlife AG, Espenstrasse
139, 9443 Widnau, Switzerland
EC REP
Printed in China