Advantech PCM-9591 Installation and operation manual

PCM-9591 Startup Manual 1
Before you begin installing your card, please make sure that
the following items have been shipped:
PCM-9591 all-in-one single board computer x1
Startup manual x1
CD disk for utility and drivers x1
Mini Jumper (10 pcs package) x1 p/n: 9689000002
Cooler (73*50*31 mm) x1 p/n:1750001620
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Note 1: For detailed contents of PCM-9591, please refer
to information on the enclosed CD-ROM (in PDF
format).
Note 2: Acrobat Reader is required to view any PDF
file.Acrobat Reader can be downloaded at:
www.adobe.com/Products/acrobat/readstep2.
html (Acrobat is a trademark of Adobe)
1.
2.
3.
4.
5.
PCM-9591 AMD Dual Core S1 SBC with HDMI/LVDS/
LAN/Audio/20 bit GPIO/ 4 SATA/NVRAM/TPM/2nd RTC
Startup Manual
General
CPU: AMD FPGA 638P S1 Processor supported
2nd Cache Memory: Depends on CPU from 512KB to
1 MB
System Chipset: AMD M690E + SB600
BIOS: AWARD 8 Mbit Flash BIOS
System Memory: 2 x 200-pin SODIMM sockets, Double
Data Rate (DDR2) up to 4 GB (Support FSB 533/667
MHz)
Power Management: APM 1.2, ACPI support
Watchdog Timer: 255-level interval timer, setup by soft-
ware, Super I/O integrated, SMSC Controller
Expansion Interface: Support one PCI-E x1 slot and one
mini PCI interface
Battery: Lithium 3 V / 220 mAH
I/O
I/O Interface: 1 x EIDE (UDMA 133), 4 x SATA 150,
1 x K/B, 1 x Mouse, 3 x RS232, 1 x RS232/422/485
USB: 8 x USB 2.0 compliant Ports
Audio: HD Audio codec ALC883, support 7.1 channel
output, LIN-IN, FRONT, MIC-IN, CEN, SUR, SIDE
IrDA: N/A
GPIO: 20 bit general purpose for input or output
Ethernet
Chipset: 1 x Realtek RTL8111B-GR
Speed: 10/100/1000 Mbps
Interface: 1 x RJ45 by cable
Standard: IEEE 802.3u 100Base-T & IEEE 802.3ab
1000Base-T
Display
Controller: AMD M690E
Side Port: Supports an optional dedicated local frame
buffer (side-port) of 64 MB through a 16 bit interface
VRAM: Share system memory up to 512 MB video
memory
LVDS LCD: 1 x 48 bit LVDS
HDMI: 1650 Mbps/channel+
DVI: Single or Dual Channel (DVi Optional)
Dual Independent Display: CRT+LVDS, HDMI+LVDS,
DVI+LVDS, CRT+DVI, CRT+HDMI (DVI Optional)
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Specications
Packing List
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/epc
For technical support and service, please visit our
support website at:
http://service.advantech.com.tw/eservice/
This manual is for the PCM-9591 series Rev. A1
Part No. 2006959100
Print in China
1st Edition,
July 2008

2 PCM-9591 Startup Manual
Specications
Mechanical and Enviromental
Dimension (mm): 203 mm (L)* 146 mm (W)
Height on Top (mm): 35 mm (Audio connector)
Height on Bottom (mm): 9.2 mm (memory socket)
Heatsink Dimension (mm): 26.5 x 26.5 x 30 mm
Weight (g): 0.85 Kg (Weight of total package)
Operating Temperature: 0 ~ 60° C (32~140° F)
Operating Humidity: 0% ~ 90% Relative Humidity,
noncondensing
Storage Temperature:
Standard products: 0 ~ 60° C
Storage temperature: -20 ~ 70° C
Storage Humidity:
Standard products: 0 ~ 60° C
Relative humidity: 95% @ 60° C
Power Supply Voltage:
- Voltage requirement with ATX Power :
+3.3 V ±5%
+5 V ±5%
+5 V Standby ±5%
+12 V ±5%
- Voltage requirement with AT Power :
+5 V ±5%
+12 V 5 V ±5%
Power Requirement:
(CPU Dual Core Turion 1.6 GHzv/2 G DDR2 )
- ATX:
Typical: 1.05 A @ +3.3 V, 0.13 A @ +5 VSB, 2.94 A @
+5 V, 1.9 A @ +12 V
- AT:
Typical: 3.66 A @ +5 V, 1.96 A @ +12 V
Jumpers and Connectors
The board has a number of jumpers that allow you to
configure
your system to suit your application.
The table below lists the function of each of the jumpers an
connectors.
•
•
•
•
•
•
•
•
•
•
•
Jumpers
Label Function
JP1
Clear COMS
JP2 LCD Power
JP3 COM2 Setting
SW1 FPGA address Strap
SW2 Custom Hardware Strap 1
SW3
Custom Hardware Strap 2
SW4 LVDS LCD Panel Setting
Connectors
Label Function
CN3 Power Connecter
CN5 Inverter Connecter
CN6 PS2 Keyboard/Mouse Connecter
CN8 CPU FAN Connecter
CN9
SATA 3 Connecter
CN10
SATA 2 Connecter
CN11
GPIO Connecter
CN13
IDE Connecter
CN15
PCIEXPRESS x1 Connecter
CN16
LVDS Connecter
CN17
SATA 1 Connecter
CN18
SATA 0 Connecter
CN19
DVI Channel2
CN21
USB Port7/9 Connecter
CN22
DVI Channel1
CN23
Panel Control Connecter
CN24
COM 3/4 Connecter
CN25
uDOC Connecter
CN26
RJ45+USB Connecter
CN27
Audio JACK Connecter
CN28
USB Connecter
CN29
VGA Connecter
CN31
COM 1/2 Connecter
CN32
System Fan
CN33
HDMI Connecter
CN34
MINIPCI Connecter
CN37 CF TYPEII Connecter

PCM-9591 Startup Manual 3
Switch Setting
SW1 FPGA Address Strap
Part Number 160000084
Deafult = 0000b (ALL ON)
HStrap3
HStrap2 HStrap1 HStrap0 Address
ON ON ON ON 0000b
(200)
(Default)
ON ON ON OFF 0001b
(280)
ON ON ON ON 0010b
(300)
ON ON ON OFF 0011b
(380)
ON OFF ON ON 0100b
(400)
ON OFF ON OFF 0101b
(480)
SW2 Custom Hardware Strap 1
Part Number 160000084
Deafult = 1111b (ALL OFF)
SW2 and SW3 are defined by customer for AP hardware
strap.
SW3 Custom Hardware Strap 2
Part Number 160000084
Deafult = 1111b (ALL OFF)
SW2 and SW3 are defined by customer for AP hardware
strap.
You can use SUSI GPIO API to read the SW2 and SW3
status. For Detail, You can refer to PCM-9591 FPGA user
manual.
SW4 LVDS LCD Panel ID Setting
Part Number 160000084
Footprint SW-4X2SS
Dexription CHS-04TA2
Deafult = 0000b (ALL OFF)
Jumper Setting
JP1 Clear CMOS
Part Number 1653003101
Description PIN HEADER 3*1P 180D (M) SQUARE
2.0 mm
Setting Function
(1-2) Normal
(2-3)
Clear COMS
123
JP2 LCD Power
Part Number 1653003101
Description PIN HEADER 3*1P 180D (M) SQUARE
2.0 mm
Setting Function
(1-2) +5 V
(2-3) +3.3 V
JP3
COM2 Setting
Part Number 1653003260
Description
PIN HEADER 3*2P 180D SMD-
MALE SQUARE PIN 2.0 mm
Setting
Function
(5-6) (7-9) (8-10)
(13-15)(14-16)
RS232
(3-4) (9-11) (10-12)
(15-17) (16-18)
RS422
(1-2) (9-11)(10-12)
(15-17) ( 16-18)
RS485
COM2 Jumper Setting
21
17 18
RS-232 RS-422 RS-485
Jumpers and Connectors
123
123
123
2
1
17 18
2
1
17 18

4 PCM-9591 Startup Manual
PCM-9591 Jumpers & Connectors (Component Side)
CN25
CN37
CN34
PCM-9591 Jumpers & Connectors (Component Side)

PCM-9591 Startup Manual 5
PCM-9591 Jumpers & Connectors (Solder Side)
0.00 [0.000]
27.88 [1.098]
0.00 [0.000]
5.13 [0.202]
5.08 [0.200]
11.69 [0.460]
14.41 [0.567]
67.13 [2.643]
78.04 [3.072]
14.63 [0.576]
0.00 [0.000]
2.30 [0.090]
9.35 [0.368]
12.18 [0.480]
12.73 [0.501]
135.89 [5.350]
140.97 [5.550]
135.89 [5.350]
193.04 [7.600]
0.00 [0.000]
40.37 [1.589]
R4.06[R0.160]
PCM-9591 Mechanical Drawing (Component Side)
PCM-9591 Mechanical Drawing (Component Side)
PCM-9591 Mechanical Drawing (Solder Side)
0.00 [0.000]
5.13 [0.202]
0.00 [0.000]
5.08 [0.200]
67.86 [2.672]
84.32 [3.320]
3.63 [0.143]
66.61 [2.623]
0.00 [0.000]
135.89 [5.350]
193.04 [7.600]
198.07 [7.798]
0.00 [0.000]
5.08 [0.200]
193.04 [7.600]
135.89 [5.350]
140.97 [5.550]
36.06 [1.420]
103.26 [4.065]
99.14 [3.903]
65.86 [2.593]