Advantech PCM-23U1DG-CE Installation and operation manual

PCM-23U1DG-CE Startup Manual 1
Before installation, please make sure that you have:
• 1 x USB dongle I/O Plate with wired cable
• 1 x Startup manual
• 1 x Warranty card
• 1 x USB dongle half-size mPCIe (PCM-23U1DG-CE)
• 1 x Full/Half-size mPCIe adapter kit (PCM-23U1DG-CE)
If any of the above items are missing or damaged, please
contact your distributor or sales representative immediately.
Please follow the steps as below.
1. Assemble half-size mini-PCIe card and bracket with
screws.
PCM-23U1DG-CE
USB Slot /w Lock for USB Dongle
Startup Manual
2. Install USB device into PCM Module.
3. Insert the PCM Module through the blanking plate hole
and secure the screws. Attach the PCM Module to the
mini-PCIe card with the cable.
The support documentation and drivers can be accessed
from Advantech website.
• Documentation
- Datasheet
Documentation/Software Support Guide
Packing List
For more information on this and other Advantech
products, please visit our website at:
https://www.advantech.com/
For technical support and service:
https://support.advantech.com/support/new_de-
fault.aspx
This startup manual is for PCM-23U1DG-CE.
Part No. 204323U100 Edition 1
April 2019
Installation
Installation (Cont.)

2 PCM-23U1DG-CE Startup Manual
The following tables and figures show the pin assignments
of the connector on the I/O module.
Description of PIN Use - On I/O Plate
CN1, USB w/locked CN2, Internal cable for USB
PIN1 +5V PIN1 +5V
PIN1 D- PIN1 D-
PIN3 D+ PIN3 D+
PIN4 GND PIN4 GND
PIN5 GND_IO
Description of PIN Use - On mPCIe Card
CN1, Internal Cable for USB
PIN1 +5V PIN2 +5V
PIN3 NC PIN1 USB-
PIN5 NC PIN3 USB+
PIN7 GND PIN4 GND
PIN9 NC
PIN Assignment (Cont.)PIN Assignment