Air Liquide MONNAL T60 User manual

This guide does not
replace the user manual
Intended for all the persons
authorized to adjust settings
Quick guide
YN031952 - May 2023 version - Photo credits: © Air Liquide - Creation: CHANH THI
Monnal EVA expiratory valve
Assembly
instructions
The use of a hydrophobic bacteriological filter on the
inspiratory outlet of the MonnalTM T60 used in hospital
environment is mandatory, in order to limit the risks of
retro-contamination (see user manual).
Cleaning protocol (see user manual).
Extraction:
press the button
Single
use valve
Autoclavable
valve
MonnalTM T60 is a class IIb air turbine medical device for the treatment of infants (from 3 kg),
children and adults, intended for hospital use and for intra/extra-hospital transport, in
emergency, post-interventional care and resuscitation rooms - The acts carried out with
MonnalTM T60 are covered by the health insurance bodies in certain situations.
Manufacturered by Air Liquide Medical Systems - Conformity assessment: GMED 0459 -
Commercial code: R.C.S. Nanterre 348 921 735 - Please read the user manual carefully.
Air Liquide Medical Systems is committed to an environmental approach with a quality-
environment management system certified ISO 14001:2015. For more information, go and
visit our website: https://www.device.airliquidehealthcare.com/our-commitments
https://www.device.airliquidehealthcare.com
Contact
AIR LIQUIDE MEDICAL SYSTEMS
Parc de Haute Technologie
6, rue Georges Besse
92182 Antony Cedex
Phone: [phone]
Hotline: [phone]
MONNALTM T60

Select
Emergency mode
or
Ventilation modes
The gender and height
settings do not aect the
selected ventilation mode. It
impactsonlytheEmergency
AVCV ventilation mode.
Select a ventilation mode, then validate
Switch on the respirator Change the ventilation mode
Adjust an alarm threshold
Adjust a ventilation setting
Disable the alarm sound
Autotests
Press the button on the left hand side of the device Press the menu
Select the alarm threshold to be adjusted
Adjust and validate by pressing the control wheel
Select the setting to be modified
Adjust and validate by pressing the control wheel
Upper threshold
Lower threshold
It is recommended to carry out an autotest everytime a
patient circuit and/or expiratory valve is replaced.
It is important to be in the appropriate configuration for the
intended use: type of patient (infant, child, adult), circuits and
filters.
After the beep and the message,
remove the plug to end the tests.
Note: pressing the padlock locks the
touchscreen.
To unlock: press the padlock and confirm
with the control wheel.
Start ventilation
Stop ventilation
Press the button to inhibit the audibe alarm
Press
Autotests
Plug the patient circuit, and then
validate to start the autotest
sequence (< 2 min)
Air transport certified