99-709852-08 Rev. 03-00 AM-011354-DS v2
What if my TV/Aux device cannot be found? (IR Learning)
How do I return my remote to Factory Settings?
Battery information
Do not mix different types of battery or old and new batteries.
Do not use rechargeable batteries.
Remove the batteries from the remote control if you are not going to use it for
several weeks, to avoid the risk of leakage.
Please respect your environment and any local regulations and dispose of old
batteries in a responsible manner.
Do not attempt to recharge the batteries.
Immediately remove any leaking batteries.
Take care when handling leaking batteries as they may cause burns to the skin or
eyes, or other physical injuries.
1. Press 1 and 6 for at least three seconds until the TV/AUX POWER key flashes twice
then stays on.
2. Enter the key sequence 9 8 1. After completing the sequence the STB key will flash
twice. The TV settings are now deleted from the remote control and it returns to
factory settings: Bluetooth mode, and unpaired.
The Maxi ATV remote control can learn a key function from another ‘source’
remote control.
1. Choose your ‘target key’ on the remote control. It must be one of the following
keys: TV/AUX POWER / TV INPUT / VOL+ / VOL- / MUTE. This key will learn a
function from the source remote control.
2. Press 4 and 6 for at least three seconds. The TV/AUX POWER key will flash twice
and remain on.
3. Press your target key within 30 seconds:
• if valid, the TV/AUX POWER key will give a confirmation flash and remain on.
• if invalid, or you do not press within 30 seconds, the TV/AUX POWER key will
give a long flash and return to user mode.
4. Hold the Maxi ATV remote control 3 - 6 cm from the source remote control
with the IR windows facing each other, then press your target key on the source
remote control (e.g. if your target key on the Maxi ATV remote control is mute,
press mute on the source remote control).
5. If the IR signal is received correctly, the TV/AUX POWER key will turn off and the
remote control will return to normal mode (note: this can overwrite a previously
learned code).
6. If the IR signal is not received correctly, or is received after 30 seconds, the Maxi
ATV remote control will not store the code from the source remote control: it
will give a long flash and return to user mode.
7. If the Back key is pressed on the remote control while it is waiting for an IR signal,
the TV/AUX POWER key will give a long flash and return to user mode. (If the
target key is pressed, any learned code on it is cleared.)
8. To clear the target key, press 4 and 6 for at least three seconds. The TV/AUX
POWER key will flash twice and remain on. Then press your <target key> twice.
The TV/AUX POWER key will flash to confirm the target key is cleared.
