
OPERATION
When the remote control is first operated all buttons transmit
commands for the set-top box. The exact button function will
depend on your specific service provider. Point the remote control
towards the front of the set-top box when pressing a remote
control button to ensure correct operation. Do not cover the IR
window at the front of the product.
When a button on the remote is pressed either the set-top box
standby button will flash (or TV standby button if a TV brand has
been entered) depending on which product is being controlled by
the remote control.
If a button is pressed for more than 30 seconds the remote control
will stop transmitting commands in order to preserve battery life.
TV control setup: Brand Search
The remote control can also be programmed to operate certain
functions of your TV set. To programme this functionality then
perform the following instructions in sequence. In case of a
mistake, the process can be exited at any point by pressing
and holding the Text/SHIFT button and then at the same time
pressing the STOP button. The remote control will revert to normal
operation and no TV brand code will be stored.
1. Determine the manufacturer of your TV set
2. Look up the 4-digit manufacturer code supplied in this manual
and make a note of this code
3. Make sure your TV set is turned on. (The set-top box does not
need to be turned on to perform this programing feature)
4. Press and hold both the 1and the 3buttons at the same time
on the remote control for approximately 3 seconds until the TV
standby button remains lit, then release both buttons
5. Now enter the 4 digit manufacturer code for your TV set. On
each digit entry the TV standby button will flash. On entry of the
4th digit the TV standby button will flash then remain lit
6. Point the remote control at the TV set and press and hold down
the TV Standby Button or the Mute button on the remote
control
7. When the TV either turns off or brings up the MUTE symbol on
screen, then release that button. This may take a few minutes to
happen
8. Press and hold the Text/SHIFT button and then at the same time
press the STOP button to finish setting up the TV control mode.
The TV standby button will go out. The TV control function is now
programmed into the remote control.
The following buttons should now operate the TV set:
TV Standby, AV source select, Volume Up, Volume Down, Mute
If not all the above mentioned buttons operate the TV set then a
KEY FIX operation can be performed. (See page 8).
Should the TV model be changed and the remote control requires
re-programming then repeat the above setup procedure with the
new TV.
Should the TV brand be not successfully found by the remote
control then the TV standby button will flash rapidly and the
remote control will revert to normal operation. No TV brand code
will be stored.