AMQ JAKU User manual

JAKU installation guide

JAKU INSTALLATION GUIDE | 2 amqsolutions.com
Backrest Base and Castors
Allen WrenchAdjustable Armrests Bolts for Seat
and Backrest
Bolts
for Armrest
Fixed Armrests
Seat Gas Lift
MAX
275 lbs
COMPONENTS

JAKU INSTALLATION GUIDE | 3 amqsolutions.com
Step 1
Base and Gas Lift Assembly
Step 2.1
Step 2
Seat and Armrest Assembly
1. Assemble on a smooth surface to avoid
scratching parts.
2. Turn the base upright and insert the gas lift.
1. Referring to the image above, place the
armrests.
2. Insert the bolts and tighten lightly with allen
wrench. Ensure bolts enter at a straight angle
before tightening fully.
1. Check the L / R mark on the bottom
of the armrests as shown.
INSTALLATION

JAKU INSTALLATION GUIDE | 4 amqsolutions.com
Step 3-A
Seat and Backrest Assembly – Smart Sync
Step 3 Seat and Backrest Assembly
Step 3-B
Seat and Backrest Assembly – Step Sync
1. Insert the groove of the backrest assembly
into the seat assembly
1. Align the connection groove between
the seat assembly and the backrest
assembly, and then insert the guide pin
into the center hole.
2. Tighten seat assembly with the backrest
assembly using the bolts (same way as
assembling the armrests).
3. Remove the guide pin and assemble to
the last bolt.
1. Insert the groove of the backrest
assembly into the seat assembly
INSTALLATION

JAKU INSTALLATION GUIDE | 5 amqsolutions.com
Step 4
Base Assembly
Step 4
Lumbar Support Assembly
1. Combine the pre-assembled seat with
the backrest.
2. Insert gas lift into the central hole of
seat plate.
3. After the assembly, press the seat with
weight to function height adjustment.
Check the height adjustment lever
works properly.
1. Check the lumbar support assembly position of the backrest (assemble under the guideline of the
backrest).
2. Insert the lumbar support assembly position. (The lumbar support assembly position is the groove
located in the center of the backrest).
3. Same way as assembling the other side.
4. When removing the lumbar support, separate one by one after bending the lumbar support.
INSTALLATION