Anet A8 User manual

Anet A8 3D Printer
Installation Guide
All manuals and user guides at all-guides.com
all-guides.com

A8 assembly parts list 1
All manuals and user guides at all-guides.com

A8 assembly parts list 2
All manuals and user guides at all-guides.com

A8 assembly parts list 3
All manuals and user guides at all-guides.com

A8 assembly parts list 4
All manuals and user guides at all-guides.com

A8 assembly parts list 5
All manuals and user guides at all-guides.com
all-guides.com

A8 assembly parts list 6
Please check printer parts quantity when you receive it.
All manuals and user guides at all-guides.com

Name of each printer part
All manuals and user guides at all-guides.com

Assembly Step 1
Step 1
Please be aware the screw holes is in
red circles
All manuals and user guides at all-guides.com

Assembly Step 2
Step 2
Please be aware the screw
holes is in black circles
All manuals and user guides at all-guides.com

Assembly Step 3
Step 3
All manuals and user guides at all-guides.com
all-guides.com

Assembly Step 4
Step 2
Step 3
All manuals and user guides at all-guides.com

Assembly Step 5
All manuals and user guides at all-guides.com

Assembly Step 6
Threaded rod 400mm
All manuals and user guides at all-guides.com

Assembly Step 7
Y Guide rod 380mm
All manuals and user guides at all-guides.com

Assembly Step 8
Attention：Leave vacancy between belt fixation
clamp and hot bed fixed plate for belt positioning.
jeweils 2 Klemmen übereinander, dass
der Riemen dazwischen kann
Later with belt
4
All manuals and user guides at all-guides.com
all-guides.com

Assembly Step 9
Attention: Please diagonally tighten the screws when all are in there place
Before Assembly
After Assembly
All manuals and user guides at all-guides.com

Assembly Step 9
Attention: Belt is for X&Y axis transmitting. Cut the length
you need to each transmission shaft. The belt is 1.5m in total
and 10-20cm left after installation.
All manuals and user guides at all-guides.com

Assembly Step 10
Attention: Hot bed screws should be in the bottom, and
wing nuts will keep the height of hot bed level as well as
firming the hotbed.
All manuals and user guides at all-guides.com

Assembly Step 11 Attention: This hole is for Z axis guide rod positioning
M2* 12 Schraube 2
M3* 30 Schraube 2
8
All manuals and user guides at all-guides.com