6.1 Retraction distance .................................................................................. 21
6.2 Retraction speed...................................................................................... 22
6.3 Temperature is too high........................................................................... 22
7. Overheating...................................................................................................... 24
7.1 Insufficient cooling................................................................................... 24
7.2 Print at too high temperature.................................................................. 25
7.3 Printing too fast........................................................................................ 25
7.4 When all above fall, try to print multiple parts at once .......................... 26
8. Layer Shifting or Misalignment ........................................................................ 27
8.1 Nozzle moves too fast.............................................................................. 28
8.2 Mechanical or Electrical issues ................................................................ 29
9. Layer Separation and Splitting.......................................................................... 31
9.1 Layer height is too large........................................................................... 32
9.2 Print temperature is too low.................................................................... 33
10. Grinding Filament............................................................................................. 34
10.1 Increase the extruder temperature ....................................................... 35
10.2 Print too fast .......................................................................................... 35
10.3 Check for a nozzle clog........................................................................... 36
11. Clogged Extruder.............................................................................................. 37
11.1 Manually push the filament to extruder................................................ 38
11.2 Reload the filament ............................................................................... 38
11.3 Clean out the nozzle .............................................................................. 39
12. Stops Extruding in the Middle of a Print .......................................................... 40
12.1 Out of filament....................................................................................... 41
