Aprimatic WK120 User manual

BASIC WK120 selector
LBT0430
Rev.00 Last print date Thursday 9 February 2017 Page 1to 3
DRAFT
DESCRIPTION
The BASIC Selector is a device controlling the automatic doors and can replace the mechanical
selector; communication with WK120 control unit is carried out through the S485 interface.
Upon switch-on, the Selector will run a test of all LEDs, then the LED corresponding to the
automatic door status will turn on.
In case of error the red LED with warning symbol will turn on, whereas if the battery is low the red LED with battery
symbol will turn on.
The Selector software cannot be updated through the PUA device (AP IMATIC Universal Programmer).
1 – SELECTOR LAYOUT
There are 8 blue LEDs indicating the status of the
automatic door, 2 red LEDs signalling errors and a push-
button to select the statuses and, if necessary, to reset
the board WK120.
2 – WK120 AUTOMATIC DOOR BOARD RESET
Simply press the push-button for more than 10
seconds, until all blue LEDs light up in clockwise sequence, to reset the board of the automatic door.
The reset cycle lasts approximately 10 seconds.
3
– AUTOMATIC DOOR STATUS
Upon switch-on, the Selector will display the automatic door status by turning on first the flashing blue LED of the
It flashes in
"PROGRAMMING"
mode
Blu Led
Red Led
Button
Press the Button over 10
seconds RESET in progress:
Led rotating clockwise

BASIC WK120 selector
LBT0430
Rev.00 Last print date Thursday 9 February 2017 Page 2to 3
DRAFT
bidirectional status, then the steady blue LED of the door status.
- Push-button: To change the door status press the central push-button for 2 seconds until the LED starts
flashing; then press the push-button up to the desired status, after 2 seconds the LED will be steady on and the door
will set to the selected status.
If a "lock delay" higher than zero has been programmed and the "lock status" is chosen, the output status LED
(internal radar) will turn on together with the flashing padlock LED; once time runs out the lock status LED will
stay on and the automatic door will lock.
Double way External RADAR PARTIAL Pharmacy
Lock OPEN Internal RADAR Delayed Lock

BASIC WK120 selector
LBT0430
Rev.00 Last print date Thursday 9 February 2017 Page 3to 3
DRAFT
4 – ERROR SIGNALLING
Signalling through red LED with triangle warning symbol:
1. fast flashing = S485 communication error with control unit.
2. slow flashing =error relevant to board PA1013.
3. steady on =cyclic test in progress.
Should a low battery error occur (control unit error E05), this will not be signalled through the red LED with the
triangle warning symbol, but through the slow flashing of the red LED with the battery symbol.
NOTE During parameter editing from the equipment and/or the PRO keyboard, the danger symbol continues flashing
until edit parameters mode is quitted.
Error signalling table
T IANGLE symbol red LED
BATTE Y symbol red LED
no communication with control unit
fast flashing
off
WK
120
control unit error
slow flashing
off
cyclic test in p
rogress
steady on
off
low battery
off
slow flashing
5 – ELECTRIC CONNECTIONS
WK120
WK120