Argos 459/4598 User manual

3
3
Issue 2: 05/
09/15
Please openall 3 boxes before commencing assembly of the set.
This box contains 2 chairs.
nuts
High Back Cube Chair
459/4598
3
For further assistance please visit http://www.argos-support.co.uk/

1
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
pages 2.
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Do not stand or put weight on the
product during assembly, this could
cause damage.
Assemble the item as close
room) as possible.
Assemble on a soft level
surface to avoid damaging the
chair or your floor.
Parts of the assembly will be
easier with 2 people.
We do not
recommend the
use of power
drill/drivers for
inserting screws ,
as this could damage the unit.
Only use hand screwdrivers.
Dispose of all packaging
carefully and responsibly.
Care and mainte nance
Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
r
the e are no loose nuts on
F om time to time check that
r
this chair.
This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
Make sure each studs
matches the corresponding
figure to ensure correct
assembly.
Assemble all par ts and nuts
loosely during assembly,only
once the product is complete
should you fully tighten the
nuts.
Maximum safe seated
weight: 110kgs.

The quantities below are the correctamountto complete the assembly.In some cases more
fittings may be supplied than are required.
1234
56
C
Tools required
Stud x 9 Nut x 9
6X1.0
M6
M6x45
Washer x 11
DE
Screw x 2 Screw cap x 2
1 x Allen key
7
2
3
For further assistance please visit http://www.argos
-support.co.uk/

A s s e m b l y I n s t r u c t i o n s
Use stud ,washer ,
and
nut to fix the seat
panel to back panel
by wrench.
C
2
4
C
2
4
Use stud ,washer ,
and
nut to fix the left
panel and right panel
to back panel by
wrench.
C
1 3
2 C
3
1
2
Right
Do not fully tighten
nuts at this stage.
Do not fully tighten
nuts at this stage.
3

Assembly Instructions
After all the parts are positioned, you can now fully
tighten all nuts fixed on previous steps.
Use screw washer
to fix the back to the
chair, then cover the
screw with the screw
cap .
nuts,
Fit bac k to the c hair
Tighten all the nuts
D
6
5
.
place the cushion on
the chair
D
E
E
6
7
3
4
For further assistance please visit http://www.argos-support.co.uk/