ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •2074112-INS-RB •PAGE 2
Step 1
Starting on the driver side, locate
the three mounting studs along
the inside edge of the vehicle.
Step 4
Repeat steps one and two on
the passenger side of the vehicle.
Congratulations on the installation
of your new ARIES rocker steps.
With the rocker steps installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on the
first page of this instruction manual.
Step 2
Starting at the front mounting location,
remove any debris from the factory studs.
Attach the driver-side step using
an M8 flat washer and nylock nut.
Note: Apply anti-seize to the studs
to keep the nuts from seizing up.
Repeat this process for the
middle and rear mounting locations.
Step 3
With the rocker step in position,
tighten all brackets to the vehicle.
