Aries 1110313 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287. 8 63 4 •1110313-INS-R A •PAGE 1
INSTALLATION MANUAL 1110313
Parts List
1Driver / left bracket
1Passenger / right bracket
2Spacer, 5/8"
4Spacer, 1/2"
4Button head screw, M6
4Flat washer, M6
4Lock washer, M6
2Button head screw, M8
2Flat washer, M8
4Lock washer, M8
4Carriage bolt, 1/4"
4Flat washer, 1/4"
4Nylock nut, 1/4"
Tools Required
Torque wrench -- Maintenance
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes,
polish may be used to clear small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Product PhotoLevel of Difficulty
Easy
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To help prevent damage to the product or vehicle, refer to the specified
torque specifications when securing hardware during the installation process.
Torque Specifications
Metric
M6 bolt 3 ft-lbs.
M8 bolt 7 ft-lbs.
M10 bolt 16 ft-lbs.
M12 bolt 28 ft-lbs.
SAE
1/4" bolt 3 ft-lbs.
5/16" bolt 7 ft-lbs.
3/8" bolt 16 ft-lbs.
7/16" bolt 20 ft-lbs.
1/2" bolt 28 ft-lbs.
Use above torque setting unless otherwise noted
Product Registration and Warranty
CURT Group stands behind our products with industry-leading warranties.
Provide feedback and help us to improve our products by registering your purchase at:
warranty.curtgroup.com/surveys

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287. 8 63 4 •1110313-INS-R A •PAGE 2
Step 1
Starting on the driver side, locate
the mounting points on the vehicle.
Remove any existing hardware.
Step 2
On the side attachment, use a 5/8" spacer,
an M8 bolt, lock washer and flat washer to
secure the bracket to the vehicle.
Step 3
On the top attachment, use a 5/8"
spacer, a 1/2" spacer, two M6 bolts,
lock washers and flat washers to
secure the bracket to the vehicle.
Repeat steps 2 through 3 on the
passenger side of the vehicle.
5/8" spacer
M6 bolt
M6 lock
washer
M6 flat
washer
1/2" spacer
5/8" spacer
M8 lock washer
M8 bolt
M8 flat washer

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287. 8 63 4 •1110313-INS-R A •PAGE 3
Step 5
Congratulations on the installation
of your new ARIES LED light bar brackets.
With the brackets installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on page one.
Step 4
To install a 50" LED light bar (part# 1501278
- sold separately), use two 1/4" carriage bolts,
flat washers and nylock nuts per side at each
mounting location.