Arjo Maxi Twin User manual

Maxi Twin
1. Fit the sling to the patient (ensuring correct size is used).
2. Position the Maxi Twin in front of the patient, ensuring the wide part of the
spreader bar is at, or just below shoulder level, if necessary open the chassis
legs.
3. Attach the sling attachment clips to the appropriate points on the spreader
bar.
4. Using the handset raise the patient, adjust the positioning handle until the
patient is reclined in the sling.
5. Close chassis legs and transport to chair, bed or toilet.
6. Lower the patient and adjust the positioning handle to bring them into a
suitable position.
7. Un-clip the sling attachment clips.
8. Remove the Maxi Twin, making sure patient’s feet and body are clear of the
lifter.
9. Remove the sling from the patient.
Before operating the Maxi Twin and for full descriptions and instructions on
Lifter operations, sling attachment safety warnings, battery charging and care
of your Maxi Twin always refer to full operating instructions for your Maxi Twin.
04.KT.02_6EN • 07/2019
ABRIDGED OPERATING INSTRUCTIONS

ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com
Unlock
Lock
Clip
Loop
Sling Attachments
1
2
3
4
5
9
6
7
8
11
12
10
8
raise
sit up
chassis
leg open
Chassis
leg close
recline
lower
1. Mast/Lifter manoeuvring handle
2. Jib
3. Adjustable chassis legs
4. Braked castors (rear)
5. Un-braked castors (front)
6. Powered DPS spreader bar
7. Control handset
8. Handset hang point
9. Lifter battery pack
10. Main lift actuator
11. Emergency stop button/Reset
button
12. System failure lower override
For additional accessories, see operating & product care instructions