Atlas Copco RT-P5 User manual

RT-P5
TORQUE CHART
This chart shows the correlation
between pump gauge psi reading
and torque output for your Rapid-Torc
RT-P5 hydraulic torque wrench.
PSI FT.LB.
1500 60
1600 64
1800 71
2000 79
2200 87
2400 95
2600 103
2800 111
3000 119
3200 127
3400 135
3600 143
3800 151
4000 159
4200 167
4400 175
4600 183
4800 191
5000 199
5200 206
5400 214
5600 222
PSI FT.LB.
5800 230
6000 238
6200 246
6400 254
6600 262
6800 270
7000 278
7200 286
7400 294
760 0 302
7800 310
8000 318
8200 326
8400 333
8600 341
8800 349
9000 357
9200 365
9400 373
9600 381
9800 389
10000 397
BAR NM
104 81
110 86
124 97
138 108
152 11 8
165 129
179 140
193 151
207 161
220 172
234 183
248 194
262 205
276 215
290 226
303 237
317 248
331 258
345 269
358 280
372 291
386 301
BAR NM
400 312
414 323
427 334
441 344
455 355
468 366
482 377
496 388
510 398
524 409
538 420
552 431
565 441
579 452
593 463
607 474
620 484
634 495
648 506
662 517
676 527
690 538
2
Set the pressure on the pump that
corresponds to the torque value.
1Find the closest torque value for
your application, either in ft-lbs
or in Nm.
FOOT-POUNDS NEWTON-METERS
RT-PTCen-RT-P5 Copyright Rapid-Torc®. Part of the Atlas Copco Group Revised October 2014
The above torque values are only applicable when using a calibrated RT-P5 hydraulic torque wrench powered by a 10,000 psi pump
fitted with a calibrated class 1 gauge.

QUICK SETUP
GUIDE
Setting up your hydraulic torque wrench for use is easy.
Please read the included user manual and safety instruc-
tion booklet for additional guidelines.
1
Wear personal protec-
tive equipment, such as
eyeglasses and steel-toe
shoes.
3
1
2
3
SET PRESSURE
Make sure the hoses are
free of any defects. The
couplers are on pump
and the tool should be
securely connected.
Place tool on at surface.
Turn pump on. Cycle the
tool. Press the “ON’ but-
ton on the remote, hold
until tool clicks. Release,
wait for the tool to click.
Repeat the cycle. Ensure
there is no leak.
4
Use the torque conver-
sion chart to set the psi
for the torque you need.
Press the remote’s “ON”
button and slowly turn
the pressure regulator
clockwise to reach the
right pressure.
FOUR BASIC STEPS TO OPERATE YOUR RT-P5
2
4
Scan the code to see a brief overview video on how to use the document or go to
rapidtorc.com/torque_setup
RT-PTCen-RT-P5 Copyright Rapid-Torc®. Part of the Atlas Copco Group Revised September 2014
CYCLE YOUR TOOL
CONNECT HOSES
WEAR PPE