AVer AVerVision VP-1HD Installation guide

VP-1HD FAQ
There is no picture on the presentation screen.
1. Check all connections again as shown in the user manual.
2. Verify the setting of the display output device; make sure it is set to the right
input/channel.
3. If you have a laptop connected to the document camera and cannot see the
desktop on the presentation screen, please make sure to set your laptop to dual
screen display mode.
4. Check the TV/RGB switch on the side of the camera and set it accordingly to your
display device type.
I have set up the VP-1HD and checked all the connections as specified in
the user manual but I cannot get a picture on the preferred presentation
screen.
1. The unit’s power button turns Red in standby mode. Press the POWER button
again to turn and the LED light will turn Green.
2. The default camera display resolution setting is on 1024X768. If your output
device does not support this resolution; Adjust the resolution dip switch on the
side of the document camera accordingly.
3. If your output device is a TV or any analog device, please switch the TV/RGB dip
switch to TV.
The picture on the presentation screen is out of focus.
1. Check your output device’s focus adjustment.
2. Press the auto focus button on your document camera’s control panel.
3. Power-cycle your camera.
There is no computer signal on the presentation screen.

1. Check all cable connections among the display device, VP-1HD and your PC,
replace cables if necessary.
2. Connect your PC to the VP-1HD first before you power on your computer.
3. Make sure to switch your Laptop to dual screen display mode by holding Fn and
repeatedly toggling the F5 key. For different command, please refer to your
laptop manual.
Can you use the AVervision software with the VP-1HD ?
1. Yes. The VP-1HD have a USB port therefore you can connect this camera to your
computer to use the Software.
Is there a light source on the VP-1HD ?
1. No. The VP-1HD does not have a built in lamp, it uses ambient light in your
environment.
The brightness on the presentation screen is dark and unreadable
1. Press the Brightness level control buttons on the control panel to adjust the
brightness.
2. Make sure there is sufficient lighting in the room.
3. Your projector’s bulb may need to be changed.