4 9418E841020E
©
Copyright 2019 Axiomtek Co., Ltd.
Version A3 ctober 2019
Printed in Taiwan
Side View
Quick Start
The basic procedures required to power on CAPA841/842:
(1). Require power at minimum 2.5A. Ensure that power supply is
OFF before connecting to CAPA841/842 and that all
necessary peripheral devices are plugged properly.
(2). Ensure all of the jumpers are at default settings; especially
JP10 (1-2 close).
(3). Firmly install DDR3L memory modules into connector
SSODIMM1 until fully seated.
Note: It must be DDR3L memory module.
(4). Firmly insert power to ATX1.
(5). Install a momentary on/off button/switch onto CN1, pin 9 and
10.
(6). Turn on the power supply.
(7). Press the on/off button/switch to power on CAPA841/842
CAPA841/842 Series Quick Installation Guide
9418E841020E 1
©
Copyright 2019 Axiomtek Co., Ltd.
Version A3 ctober 2019
Printed in Taiwan
Checklist
Audio Cable x1
COM Port Cable with Bracket,
P=2.0mm x1
Note: Please contact your local vendors if any damaged or missing items. DO
NOT apply power to the board if there is any damaged component.
Note: If the CPU board is with heatspreader, instead of
heatsink, please install cables prior to screwing heatspreader.
Jumper Settings
Before applying power to the CAPA841/842, please make sure all of the
jumpers are in factory default positions.
Jumper
Description Setting
JP1 LVDS +3.3V/+5V Voltage Selection
Default: +3.3V 1-2 Close
JP2 Audio Output Selection
Default: Line-out 1-3, 2-4 Close
JP3 LVDS Brightness Control Mode Setting
Default: PWM Mode 1-2 Close
JP4 Restore BIOS Optimal Defaults
Default: Normal Operation 1-2 Close
JP6 LVDS +12V Voltage Selection
Default: None None
JP7 COM4 Data/Power Selection
Default: RS-232 Data CN11 Pin 11: DCD
3-5 Close
CN11 Pin 18: RI 4-6 Close
JP8 COM3 Data/Power Selection
Default: RS-232 Data CN11 Pin 1: DCD 3-5 Close
CN11 Pin 8: RI 4-6 Close
JP10 Auto Power On
Default: Disable 1-2 Close
JP11 COM2 Data/Power Selection
Default: RS-232 Data COM2 Pin 1: DCD
3-5 Close
COM2 Pin 8: RI 4-6 Close
JP12 COM1 Data/Power Selection
Default: RS-232 Data COM1 Pin 1: DCD
3-5 Close
COM1 Pin 9: RI 4-6 Close
CAPA841/842 Intel
®
Processors Capa Board
